• No results found

active vibration damping system

FULL CAR ACTIVE DAMPING SYSTEM FOR VIBRATION CONTROL

FULL CAR ACTIVE DAMPING SYSTEM FOR VIBRATION CONTROL

... and active damping system mathematical model was ...and active damping using Linear Quadratic Regulator controller (LQR)Road profile 1 has three bumps with amplitude of ...for ...

17

Field Programmable Gate Array Implementation of Active Control Laws for Multi-mode Vibration Damping

Field Programmable Gate Array Implementation of Active Control Laws for Multi-mode Vibration Damping

... experimental system is shown in Figure ...control system, a Windows based cDAQ-9178 system is used to generate stochastic excitation for acoustic excitation and ...

7

An active control method to reduce friction induced vibration caused by negative damping

An active control method to reduce friction induced vibration caused by negative damping

... the vibration that is caused due to friction induced vibration by negative damping in the disk brake ...FIV system, vibration and noise are in fact gradually reduced but still a ...

16

Self powered Vibration Control using Piezoelectric Materials in High Precision Machines

Self powered Vibration Control using Piezoelectric Materials in High Precision Machines

... standalone system is proposed consisting of piezoelectrics and circuitry that is ...of vibration excitation, which is the scanning motion in this case, in order to damp the ...the vibration ...

41

Pole assignment using state feedback with time delay in friction-induced vibration problems

Pole assignment using state feedback with time delay in friction-induced vibration problems

... of active damping and active stiffness, with time delays either inherent in the systems or introduced ...open-loop system, which can be directly measured to avoid modelling ...friction-induced ...

18

An Approach of Vibration Control Based on the Design of Three DOFs Active Vibration Damping Platform

An Approach of Vibration Control Based on the Design of Three DOFs Active Vibration Damping Platform

... cutting vibration of micro-milling is more complex than that of common ...milling. Vibration is an inextricable part of machining process which has detrimental effects on part quality, tool life, and ...

6

Nonlinear damping based semi-active building isolation system

Nonlinear damping based semi-active building isolation system

... base-isolation system with a low stiffness that is designed to shift the natural frequency of the building below the frequencies of the ground motion due to ...nonlinear damping is proposed in this ...

17

Vibration damping in bolted friction beam-columns

Vibration damping in bolted friction beam-columns

... similar system has been previously considered by Popp et al [1] where the optimum normal force required was defined based on the maximum dis- sipated ...friction damping effect only occurs when static ...

38

Review on Particle Damping Technique for Vibration Suppression

Review on Particle Damping Technique for Vibration Suppression

... oscillatory system that has the effect of reducing, restricting or preventing its oscillations Active and passive damping techniques are common methods of attenuating the resonant vibrations excited ...

6

Active vibration control

Active vibration control

... current damping system. In this system, a magnet is moved in opposition to conductors attached to the vibrating structure such that the conductors cut the perpendicular components of the permanent ...

107

Semi active damping control for vibration isolation of base disturbances

Semi active damping control for vibration isolation of base disturbances

... When performing numerical simulations with semi-active dampers the so-called chatter problem occurs under certain dynamic conditions. To observe the onset and persistence of chatter in a on-off skyhook ...

194

Active Damping of Milling Vibration Using Operational Amplifier Circuit

Active Damping of Milling Vibration Using Operational Amplifier Circuit

... on active control were reported in ...[31]. Active control was proposed based on delayed state feedback control and discrete opti- mal control ...on active magnetic bearing was verified to regulate ...

8

The Damping Materials Selection and Topology Optimization of Body Floor Yu Duan 1, Hao Chen*1

The Damping Materials Selection and Topology Optimization of Body Floor Yu Duan 1, Hao Chen*1

... e (1-3) Complex modal method is to describe a method of viscoelastic damping material performance, in some ways than the generalized differential model or generalized standard model is convenient.According to the ...

8

Analysis and control of semi-active suspension system for  a quarter car model

Analysis and control of semi-active suspension system for a quarter car model

... high damping coefficient dampers are used or the road holding condition if low damping coefficient dampers are ...suspension system, which could vary damping coefficient on the basis of road ...

6

Numerical sensitivity studies on vibration propagation and damping

Numerical sensitivity studies on vibration propagation and damping

... selecting damping values for reinforced concrete structure under different conditions can be found in ...a damping value of 2% from the critical damping value (corresponding to damping ratio ...

10

Experimentation and t-Test of Viscoelastic Vibration Damping

Experimentation and t-Test of Viscoelastic Vibration Damping

... 5) From the result obtained for the similar set of conditions the (12 mm) the average vibration magnitude (RMS Value) for silicone rubber is 247.60 mm/s 2 , for butyl 388.84 mm/s 2 and for PVC 287.57 mm/s 2 . This ...

8

On-site vibration test of PWR reactor-coolant loop in application for construction plan license after great east Japan earthquake

On-site vibration test of PWR reactor-coolant loop in application for construction plan license after great east Japan earthquake

... 3% damping ratio has been employed for seismic analysis of Reactor Coolant Loop (RCL) in PWR plants since ...1% damping ratio was used originally. In 1980s, vibration tests of steam generators (SGs) ...

8

A Time History Method for Analysing Operational Piping Vibrations

A Time History Method for Analysing Operational Piping Vibrations

... F x t = EI  u x t (46) Bending Stress = M Z (47) As a measure of structural integrity a mechanical de- sign check against fatigue is required to be carried out using the stress distribution. In the time domain it is ...

9

Vibration Damping Analysis of Lightweight Structures in Machine Tools

Vibration Damping Analysis of Lightweight Structures in Machine Tools

... The experimental tests show that the AFS structure has a stiffness greater than the conventional ram stiffness of 152.7% in Z-axis, 11.4% in X-axis and 14.7% in Y-axis. This point guarantees to withstand the forces ...

14

Vibration Damping Characteristics of Hybrid Polymer Matrix Composite

Vibration Damping Characteristics of Hybrid Polymer Matrix Composite

... the damping characteristics of Hybrid polymer composite, which can be used in many applications and in engineering ...The damping characteristics were evaluated using free and forced vibration test ...

6

Show all 10000 documents...

Related subjects