AZ31 Mg alloy
Performance of Mg-air Battery Based on AZ31 Mg Alloy Sheets with Different Grain Sizes
... of Mg-air batteries. AZ31 Mg alloy sheets with different grain sizes were obtained through cold-rolling and ...that AZ31 Mg alloy sheets with fine grain sizes have higher ...
7
Solid Recycling of an AZ31 Mg Alloy with a Vapor Deposition Coating Layer of High Purity Mg
... Mechanical properties of the solid recycled specimen and the virgin extruded specimen by tensile tests are summarized in Table 1, respectively. The solid recycled specimen exhibited the ultimate tensile strength of 268 ...
5
Influence of Rolling Routes on Press Formability of a Rolled AZ31 Mg Alloy Sheet
... Microstructure, tensile properties and press formability of AZ31 Mg alloy sheets processed by unidirectional rolling, reverse rolling and cross rolling were investigated. The intensity in (0002) ...
6
Mechanical Properties and Press Formability at Room Temperature of AZ31 Mg Alloy Processed by Single Roller Drive Rolling
... Mechanical properties and press formability at room temperature of AZ31 Mg alloy processed by single roller drive rolling were compared with those of the one processed by normal rolling. The single ...
7
Clarification of the Fracture Location in Friction Stir Processed AZ31 Mg Alloy through Examination of Globe and Miniature Specimens
... processed AZ31 Mg alloy were extracted primarily from speci fi c positions corresponding to the stir zone to explore the tensile responses of ...
6
Mechanical Properties and Resonant Characteristics of Friction Stirred AZ31 Mg Alloy
... of Mg alloys have revealed that fine recrystallized grains with a high density of dislocations possess better hardness, tensile properties and ...stirred AZ31-Mg alloy has still not been ...
6
Mechanical Properties and Blow Forming of Rolled AZ31 Mg Alloy Sheet
... Rolling was conducted at 373–673 K for AZ31 Mg alloy; mechanical properties of the rolled Mg alloy were investigated by tensile and blow forming tests. The grain sizes of all the rolled ...
6
Influence of Grain Size on Elongation at Elevated Temperatures in AZ31 Mg Alloy
... photograph with low magnification for the specimen with the grain size of 60 mm and (b) is a photograph with high magnification for the specimen with the grain size of 60 mm and (c) is a photograph with low magnification ...
6
In Situ Evaluation of Detwinning Behavior in Extruded AZ31 Mg Alloy by AE
... Tension twinning readily occurs under compressive loading along extrusion direction because extruded AZ31 Mg plate has the texture with the basal planes parallel to the extrusion direction. Detwinning ...
6
An Investigation of the Weld Current Characteristics on Twining and Tensile Strength of the AZ31 Alloy Sheet Joint Welded By GTAW
... As perceived in Fig. 3. HAZ of the pulsed current specimen exhibited big equiaxial grains and quite few twin grains and boundaries. For this property cause, it can be stated that the twin structure has taken place in ...
7
Effect of CaO Addition on the Ignition Resistance of Mg Al Alloys
... pure Mg with CaO under an ambient atmosphere at 1,073 ...which Mg alloys are oxidized at a rapid ...pure Mg increased. The ignition temperature of 0.1 mass%CaO added pure Mg was much higher ...
6
Fabrication & Characterisation of Mg- MWCNT & AZ31-MWCNT Nanocomposites
... Experimental density (ρ) measurements are calculated in accordance with Archimedes’s principle on specimens of pure Mg, AZ31 Mg alloy and Mg-MWCNT, AZ31 Mg ...
6
Fabrication and Characterization of Mg(OH)2 Films on AZ31 Magnesium Alloy by Alkali Treatment
... of AZ31 Mg alloy of dimensions 20 mm ×20 mm ×2 mm were used as the substrate ...The alloy samples were soaked in 100 ml of 5 M NaOH aqueous solution at 85 o C for 3, 6 and 12 h, and they were ...
12
Investigation on Fracture Mechanisms in Mg alloy AZ31 Nano Composites Reinforced with Multi Wall Carbon Nano Tubes
... Abstract: Mechanical properties of Metal-Matrix Composites (MMCs) can be enhanced significantly by the reinforcement of MWCNTs(Multi Wall Carbon Nano Tubes) into AZ31 Mg alloy. Efforts are underway ...
6
Dissimilar Friction Stir Welded Joints between 2024 T3 Aluminum Alloy and AZ31 Magnesium Alloy
... Al alloy related region or AZ31 Mg alloy is lying one on ...Al alloy on the advancing ...Al alloy side occurred more frequently than Mg alloy side, and this may be ...
5
Development of Small Scale Impact Three Point Bending Test Apparatus and Evaluation of Impact Fracture Properties of Mg 6%Al 1%Zn 2%Ca Alloy
... addition of Ca more than the solubility. It is suggested that due to the cracks propagates along the interface between α-magnesium and the precipitates clumped together around the grain boundary, the fracture surface of ...
8
Microstructural Development in Friction Welded AZ31 Magnesium Alloy
... Microstructural development of friction welded AZ31 alloy was studied. The microstructures near weld interface consist of mainly three regions that are recrystallized fine-grain, mixed-grain and twin ...
6
Microstructures and Tensile Properties of ECAE Processed and Forged AZ31 Magnesium Alloy
... (1) In ECAE-processed specimens with large diameter, when the number of passes is small, a heterogeneous microstructure is observed, and the basal planes are parallel to the extrusion direction. However as the number of ...
8
Surface Treatment to Provide a Metallic Luster to AZ31 Magnesium Alloy
... Figure 9 shows the relation between the amount of oxidation magnesium per unit film thickness and luster stability. 7) The amount for the film on the specimen surface after acid aqueous solution treatment was more than ...
6
A Composite Anodic Coating Containing Graphene on AZ31 Magnesium Alloy
... using the Tafel fitting method from the curves listed in Table 2. It can be observed that the corrosion potential, corrosion current density and Tafel slope of the uncoated sample were -1.49 V, 23.4 μA and 175.3 mV/dec, ...
15