• No results found

Boundary Layer Thickness

On linking the filter width to the boundary layer thickness
in explicitly filtered large eddy simulations of
wall bounded flows

On linking the filter width to the boundary layer thickness in explicitly filtered large eddy simulations of wall bounded flows

... the boundary layer thickness (BLT), which is considered the same size as the largest eddy (Tennekes and Lumley 1972)? It then raises the second question: how can we select the percentage of a ...

184

Respiratory function of the plastron in the aquatic bug Aphelocheirus aestivalis (Hemiptera, Aphelocheiridae)

Respiratory function of the plastron in the aquatic bug Aphelocheirus aestivalis (Hemiptera, Aphelocheiridae)

... have to surface to replenish the bubble, including some beetles (Madsen, 2008, 2012). A. aestivalis and some other species of Aphelocheirus may be the largest plastron insects at approximately 40 mg body mass (Xie and ...

7

SLIP EFFECT ON HEAT AND MASS TRANSFER IN CASSON FLUID WITH CATTANEO-CHRISTOVE HEAT FLUX MODEL

SLIP EFFECT ON HEAT AND MASS TRANSFER IN CASSON FLUID WITH CATTANEO-CHRISTOVE HEAT FLUX MODEL

... hydrodynamic boundary layer thickness is reduced ...the boundary layer regime for all cases of assisting, opposing and ...The thickness of thermal boundary layer ...

10

Investigating the Impact of Air Temperature on the Performance of a Tesla Turbine - Using CFD Modeling

Investigating the Impact of Air Temperature on the Performance of a Tesla Turbine - Using CFD Modeling

... when boundary layer thickness is approximately equal to inter disk ...Because thickness of boundary layer depends on viscosity and pressure, various fluids cannot be ...

9

An Analytical Investigation of the Physical Dimensions of Natural Convection Flow on a Vertical Heated Plate

An Analytical Investigation of the Physical Dimensions of Natural Convection Flow on a Vertical Heated Plate

... thermal boundary layer thickness with Prandtl number of laminar free convection on a vertical uniform heat flux plate was measured by Carey and Mollendorf ...the thickness of boundary ...

5

Boundary Layer Interaction in Hypersonic Air Intake

Boundary Layer Interaction in Hypersonic Air Intake

... A structured Mesh was generated for two dimensional model of the hypersonic intake by using ICEM CFD software. The Mesh generated is used for flow simulation using Ansys Fluent. A steady state, density based solver was ...

5

AN INTEGRAL ENERGY EQUATION MODEL FOR HEAT CONVECTION TO TURBULENT BOUNDARY LAYER ON A FLAT PLATE

AN INTEGRAL ENERGY EQUATION MODEL FOR HEAT CONVECTION TO TURBULENT BOUNDARY LAYER ON A FLAT PLATE

... the boundary layer thickness and temperature profile in laminar viscous sublayer and fully developed turbulent boundary layer, as well as the heat transfer coefficient for forced ...

8

THERMAL AND MOMENTUM SLIP EFFECTS ON HYDROMAGNETIC CONVECTION FLOW OF A WILLIAMSON FLUID PAST A VERTICAL TRUNCATED CONE

THERMAL AND MOMENTUM SLIP EFFECTS ON HYDROMAGNETIC CONVECTION FLOW OF A WILLIAMSON FLUID PAST A VERTICAL TRUNCATED CONE

... the boundary layer ...thermal boundary layer ...momentum boundary layer thickness is lesser than thermal boundary layer ...

9

Cooling of a Pr

Cooling of a Pr<1 fluid in a rectangular container

... periodic boundary conditions was found to have no spanwise, z, variation and to be symmetric about the plane x = ...the boundary layers generated on the spanwise walls. These boundary layers have a ...

24

Effect of nonlinear thermal radiation on double-diffusive mixed convection boundary layer flow of viscoelastic nanofluid over a stretching sheet

Effect of nonlinear thermal radiation on double-diffusive mixed convection boundary layer flow of viscoelastic nanofluid over a stretching sheet

... thermophoresis parameter enhance both temperature θ(η) and concentration ϕ(η) profiles. Physically, thermophore- tic parameter increases the density of the thermal bound- ary layer. As a result, temperature rises ...

18

Energetic Balance for the Flow Induced by a Constantly Accelerating Plate in a Second Grade Fluid

Energetic Balance for the Flow Induced by a Constantly Accelerating Plate in a Second Grade Fluid

... the boundary layer thickness corresponding to the unsteady flow of a second grade fluid, due to a constantly accelerating plate, are established in exact and ap- proximate ...

5

Swept boundary layer transition

Swept boundary layer transition

... the boundary layer integral parameters, where once more all plots are for unskewed traverses relative to the reference plane, ...the boundary layer – always within 30% of the boundary ...

280

Transient integral boundary layer method to calculate the translesional pressure drop and the fractional flow reserve in myocardial bridges

Transient integral boundary layer method to calculate the translesional pressure drop and the fractional flow reserve in myocardial bridges

... the boundary layer. The increased boundary layer thickness in the downstream stenosis suggests lower retarding forces, however, the core flow velocity is increased there so that ...

25

CFD analysis of 2D and 3D airfoils using open source solver SU2

CFD analysis of 2D and 3D airfoils using open source solver SU2

... The open source computational fluid dynamics (CFD) software SU2 is developed for compressible flows, equipped with approximations like pre-conditioning and artificial compressibility for incompressible flows. Wind ...

49

INFLUENCE OF CATTANEO-CHRISTOV HEAT FLUX MODEL ON MHD HYPERBOLIC TANGENT FLUID OVER A MOVING POROUS SURFACE

INFLUENCE OF CATTANEO-CHRISTOV HEAT FLUX MODEL ON MHD HYPERBOLIC TANGENT FLUID OVER A MOVING POROUS SURFACE

... Pr(> lead to high-viscosity oils. The impact of non-dimensional relaxation time heat flux γ on the temperature field is analyzed in figure12 . There is a decrease in temperature when enhances. Temperature profile θ ( ...

7

Experimental Investigation of Vortex Structures in Wake of Hyperboloid-Shaped Model by Means of 2D Particle Image Velocimetry Measurement

Experimental Investigation of Vortex Structures in Wake of Hyperboloid-Shaped Model by Means of 2D Particle Image Velocimetry Measurement

... the boundary layer, which is to be explained later, so the velocity of incoming flow changes as the altitude of the model ...the boundary layer thickness developed on the model will ...

6

A Novel Similarity Solution of Turbulent Boundary Layer Flow over a Flat Plate

A Novel Similarity Solution of Turbulent Boundary Layer Flow over a Flat Plate

... and thickness of the boundary layer are presented for a turbulent flow over the flat ...and boundary layer thickness are ...

7

The boundary layer of swimming fish

The boundary layer of swimming fish

... the boundary layer profile near the body surface, such errors in velocity relative to the fish surface do not affect our calculated skin ...velocity, boundary layer thickness and their ...

22

A Study On Effect Of Fused Deposition Modeling Process Parameters On Mechanical Properties

A Study On Effect Of Fused Deposition Modeling Process Parameters On Mechanical Properties

... The print speed was varied to 20, 35, 50, 64 and 80 mm/s keeping other three parameters constant. The graphs show that tensile strength and flexural strength are almost unaffected by the print speed. When the object is ...

5

Optical thickness and effective radius of Arctic boundary-layer clouds retrieved from airborne nadir and imaging spectrometry

Optical thickness and effective radius of Arctic boundary-layer clouds retrieved from airborne nadir and imaging spectrometry

... cal thickness and effective radius from the nadir radiances of the ...optical thickness, they differ in respect to effective radius: 5 WL seems to be more sensi- tive to larger droplets (more than 10 µm ...

12

Show all 10000 documents...

Related subjects