• No results found

Confined dynamic creep test method (CDCT) results

Development and application of a new multistage confined dynamic creep test for asphalt

Development and application of a new multistage confined dynamic creep test for asphalt

... Australian dynamic creep test can be redesigned to enable multistage evaluation of creep performance of asphalt mixtures to overcome the noted ...the Confined Dynamic ...

225

An experimental method of measuring the quasi-static and dynamic confined behaviour of PMMA

An experimental method of measuring the quasi-static and dynamic confined behaviour of PMMA

... and dynamic tests performed in a strain-rate range of 1e-3/s - 1e3/s are processed with the method and compared to results of unconfined compression ...or confined conditions whereas ...

8

CREEP CHARACTERISTICS OF CHALK MARL UNDER UNIAXIAL AND CONFINED COMPRESSION STATE STRESS

CREEP CHARACTERISTICS OF CHALK MARL UNDER UNIAXIAL AND CONFINED COMPRESSION STATE STRESS

... built creep rigs, and confined compression stress ...uniaxial creep tests with vertical and lateral deformation measurements, at different stress levels which lasted for 75 to 268 days, six oedometer ...

6

Characterization of the pavement foundation with the results of the light dynamic penetrometer test

Characterization of the pavement foundation with the results of the light dynamic penetrometer test

... P4.3 P4.4 3.2 - Ensaio C.B.R. avaliação da capacidade de carga do solo compactado Para realização deste ensaio, os operadores seguiram a norma internacional ASTM D1883 - 14 “Standard Test Method for ...

13

An in Vivo Creep Test and Mechanical Modeling in Strabismus

An in Vivo Creep Test and Mechanical Modeling in Strabismus

... vivo test method is the participation of all of the tissues that are responsible for eye ...gathered creep graphs, the creep behavior of medial rectus is a nonlinear ...this test ...

7

An evaluation of the capability of data conversion of impression creep test

An evaluation of the capability of data conversion of impression creep test

... impression creep testing method to highlight the capability in determining the minimum creep strain rate data by use of conversion relationships that relates uniaxial creep test data ...

22

On the interpretation of results from small punch creep tests

On the interpretation of results from small punch creep tests

... punch test creep data in relation to the corresponding uniaxial creep behaviour of the ...the creep deformation resulting from “localised” deformations and from the “overall” deformation of ...

49

Impression creep test of a P91 steel: a round robin programme

Impression creep test of a P91 steel: a round robin programme

... 11 Test Results Converted Minimum Creep Strain Rates Generally there tends to be good agreement between the labs for the converted average impression creep strain rates (Figure ...stress ...

61

Results of dynamic penetration test – an indicator of the compaction of surface soil horizons by forestry machinery

Results of dynamic penetration test – an indicator of the compaction of surface soil horizons by forestry machinery

... roots. Dynamic penetration test is a field survey method, primarily designed for assessment of compaction in earth dams and road or railway embankments and also for determination of soil ...

12

Preliminary Results on Dynamic Analysis of a New Test Rig for Wheel-Rail Contact Studies

Preliminary Results on Dynamic Analysis of a New Test Rig for Wheel-Rail Contact Studies

... reduced–scale test rig consisting of rotating wheel components on a ring–shape rail track system was developed for wheel-rail contact ...small-scale test rig was determined. Using finite element ...

11

Evaluation of permanent deformation of CRM reinforced SMA and its correlation with dynamic stiffness and dynamic creep

Evaluation of permanent deformation of CRM reinforced SMA and its correlation with dynamic stiffness and dynamic creep

... 4.2. Dynamic Creep Results. The dynamic creep test is used because it is ranked between the wheel tracking test and static creep and its ability to quantify the ...

8

Fixing Efficiency Values by Unfixing Compressor Speed: Dynamic Test Method for Heat Pumps

Fixing Efficiency Values by Unfixing Compressor Speed: Dynamic Test Method for Heat Pumps

... performance test method which better reflects the dynamic behavior of heat ...a dynamic test method for the evaluation of the seasonal performance of heat pumps by means of ...

16

Developing the multiple stress–strain creep recovery
(MS SCR) test

Developing the multiple stress–strain creep recovery (MS SCR) test

... as results are sensitive to sample geometry. The ‘hot pour’ method was applied as recommended to attain maximum repeatability and consistency (Airey and Hunter, ...

31

Life Estimation of HMC Package under Dynamic Load Condition and Correlation of Analysis and Test Results

Life Estimation of HMC Package under Dynamic Load Condition and Correlation of Analysis and Test Results

... severe dynamic loads which may lead to fatigue failure at leads and solder ...to dynamic load testing to save the time and huge ...the method of designing and analyzing the HMC package subjected for ...

7

CREEP STOP Farmer survey results

CREEP STOP Farmer survey results

... Thistle Rust: A Potential Biocontrol Agent to Help in the Management of Canada Thistle - MSU Extension IPM Program.. Thistle rust potential for reducing Canada thistle[r] ...

21

Correlations between the results of dynamic penetration test (dp) with standard penetration test (SPT)

Correlations between the results of dynamic penetration test (dp) with standard penetration test (SPT)

... RESUMO Não se conhecem métodos que permitam interpretar teoricamente os resultados dos ensaios com o Penetrómetro Dinâmico (DP) para obter parâmetros mecânicos do terreno, e as correlações empíricas que existem têm pouca ...

9

Assessment of Thermal Stresses in Asphalt Mixtures at Low Temperatures Using the Tensile Creep Test and the Bending Beam Creep Test

Assessment of Thermal Stresses in Asphalt Mixtures at Low Temperatures Using the Tensile Creep Test and the Bending Beam Creep Test

... TCT test bends from the strait line for long times of ...BBCT test trials in +20°C for the lowest possible stress suggested destruction of the specimen for times of loading longer than 200 seconds ...

20

Determination of creep damage model based on 316h creep tensile test conducted at 550℃

Determination of creep damage model based on 316h creep tensile test conducted at 550℃

... by creep rupture or ductile fracture after stable creep crack ...and creep crack ...and creep crack growth. This paper proposes a combined creep and plastic damage model to simulate ...

9

Creep rupture assessment by a robust creep data interpolation using the linear matching method

Creep rupture assessment by a robust creep data interpolation using the linear matching method

... the creep rupture limit can be calculated by an iterative process which leads to a unique solution, considering only the most relevant points of the loading cycle (Chen et ...of creep costitutive equations ...

29

Development of a Particle Method for Elastic and Creep Deformation

Development of a Particle Method for Elastic and Creep Deformation

... particle method for elastic and creep analysis is developed. This method is based on the concept of MPS (Moving particle semi-implicit) method which was developed for fluid ...particle ...

10

Show all 10000 documents...

Related subjects