• No results found

Cooling Performance

IMPROVING ENGINE OIL COOLING PERFORMANCE FOR VEHICLE USAGE

IMPROVING ENGINE OIL COOLING PERFORMANCE FOR VEHICLE USAGE

... When the internal combustion engine is operating at a full throttle the maximum temperature reached by the burning gas is as high as 2700 o C (pulkrabek,1997). The system produced to control the temperature in the ...

8

Endovascular Cooling Catheter for Selective Brain Hypothermia: An Animal Feasibility Study of Cooling Performance

Endovascular Cooling Catheter for Selective Brain Hypothermia: An Animal Feasibility Study of Cooling Performance

... of cooling. Temperature drops were averaged over the cooling phase and were compared within a linear regression model, accounting for repeated measurements by using the generalized estimating equation ...

7

Analysis of I.C. Engine Fins for Effective Cooling Performance

Analysis of I.C. Engine Fins for Effective Cooling Performance

... Mohsin A. Ali and Prof. (Dr.) S.M Kherde[4] – Insufficient removal of heat from engine will lead to high thermal stresses and lower engine efficiency. The cooling fins allow the wind to move the heat away from the ...

6

Cooling Performance Analysis in Disc Brake System by ANSYS

Cooling Performance Analysis in Disc Brake System by ANSYS

... ABSTRACT : Disc brake systems play a vital role in automobile field like in two wheelers to stop the heavy and high speed vehicle in less time. In applying the brakes the generation of heat in brake system and its ...

8

Analysis of effect of 
		sub cooling performance of vapor compression refrigeration system with 
		cooling load variation

Analysis of effect of sub cooling performance of vapor compression refrigeration system with cooling load variation

... system performance, phase refrigerant is cooled further to become subcool ...the performance of refrigeration systems up to ...on cooling machine using the working fluid R-22 can increase the ...

6

Study of Degradation of Dry Cooling Tower Performance under Wind Conditions and Method for Tower Efficiency Enhancement (RESEARCH NOTE)

Study of Degradation of Dry Cooling Tower Performance under Wind Conditions and Method for Tower Efficiency Enhancement (RESEARCH NOTE)

... the cooling towers, and thus, significantly deteriorates the heat transfer performance at lateral ...the performance of cooling ...the cooling tower intakes with the aim of preventing ...

7

Performance of Gas Turbine Film Cooling with Backward Injection

Performance of Gas Turbine Film Cooling with Backward Injection

... the cooling effectiveness in the span- wise direction at different downstream locations (l) on pressure and suction sides, ...the cooling whole tip. On the pressure side, the cooling ef- fectiveness ...

6

Significant factors affecting the forced air cooling process of polylined horticultural produce : a thesis presented in partial fulfilment of the requirements for the degree of Doctor of Philosophy in Food Technology at Massey University, Palmerston North

Significant factors affecting the forced air cooling process of polylined horticultural produce : a thesis presented in partial fulfilment of the requirements for the degree of Doctor of Philosophy in Food Technology at Massey University, Palmerston North, New Zealand

... rapid cooling of the produce without incurring excessive operational costs due to the running of the fan ...the cooling performance of the MBP and system variations, unconstrained by the availability ...

294

Significant factors affecting the forced air cooling process of polylined horticultural produce : a thesis presented in partial fulfilment of the requirements for the degree of Doctor of Philosophy in Food Technology at Massey University, Palmerston North

Significant factors affecting the forced air cooling process of polylined horticultural produce : a thesis presented in partial fulfilment of the requirements for the degree of Doctor of Philosophy in Food Technology at Massey University, Palmerston North, New Zealand

... overall cooling performance (cooling rate, uniformity, power consumption and pallet throughput per week) can be improved by controlling the airflow distribution between the fastest and slowest ...

19

Lattice design and expected performance of the muon ionization cooling experiment demonstration of ionization cooling

Lattice design and expected performance of the muon ionization cooling experiment demonstration of ionization cooling

... its cooling performance as described in Sec. IV . The performance of the optimized lattice, though reduced compared to that described in [15], is sufficient for the principle of ...

11

Lattice design and expected performance of the Muon Ionization Cooling Experiment demonstration of ionization cooling

Lattice design and expected performance of the Muon Ionization Cooling Experiment demonstration of ionization cooling

... its cooling performance as described in Sec. IV . The performance of the optimized lattice, though reduced compared to that described in [15], is sufficient for the principle of ...

11

Experimental and simulation study on the effect of geometrical and flow parameters for combined hole film cooling

Experimental and simulation study on the effect of geometrical and flow parameters for combined hole film cooling

... Film cooling method was applied to the turbine blades to provide thermal protection from high turbine inlet temperatures in modern gas ...film cooling is one of the ways to further enhance the film ...

45

Exergy Based Performance Analysis of a Shower Cooling Tower

Exergy Based Performance Analysis of a Shower Cooling Tower

... for cooling circulating water [1] to [3]. In a conventional cooling tower, fill material acts as the media of heat and mass transfer, by means of which the waste heat is rejected from the ...of ...

9

Investigation of High Temperature Operation Emitter Turn Off Thyristor (ETO) and Electro Thermal Design of Heatpipe Based High Power Voltage Source Converter Using ETO

Investigation of High Temperature Operation Emitter Turn Off Thyristor (ETO) and Electro Thermal Design of Heatpipe Based High Power Voltage Source Converter Using ETO

... All of the previously mentioned problems can be taken care of, if we go for a simplified air cooling system. There is hence a need for an air cooled heat radiator or heat sink that can meet the thermal ...

124

Generative Topographic Mapping by Deterministic Annealing

Generative Topographic Mapping by Deterministic Annealing

... the cooling process, which a ff ects the speed of convergency, in general it should be slow enough to get the optimal ...fixed cooling schemes, exponential cooling schemes in which temperature T is ...

10

Individual Differences in Cognitive Performance Regulated by Deep Brain Activity during Mild Passive Hyperthermia and Neck Cooling

Individual Differences in Cognitive Performance Regulated by Deep Brain Activity during Mild Passive Hyperthermia and Neck Cooling

... Continuous Performance Test (CPT) [37], which includes both proactive (AX-CPT) and reactive (SRT-CPT) ...task performance as a function of the DBA index, which can be calculated from measured ...

12

Investigation of the trends of electricity demands in Jordan and its susceptibility to the ambient air temperature towards sustainable electricity generation

Investigation of the trends of electricity demands in Jordan and its susceptibility to the ambient air temperature towards sustainable electricity generation

... and cooling regions represent the susceptibility in general and the active sensitivity in particular of electricity demand to the increase or decrease in temperature beyond comfort ...

18

The performance of the refrigerants R-134a, R-290, R404a, R-407c and R-410a in air conditioners and refrigerators

The performance of the refrigerants R-134a, R-290, R404a, R-407c and R-410a in air conditioners and refrigerators

... A schematic outlay o f the experimental set-up is given in Figure 1. It was a vapor compression refrigeration and/or heat pump cycle. The compressor was a hermetically sealed, reciprocating type with a nominal ...

8

Case Studies of Energy Saving and CO2 Reduction by Cogeneration and Heat Pump Systems

Case Studies of Energy Saving and CO2 Reduction by Cogeneration and Heat Pump Systems

... Following the crisis of the Great Eastern Japan Earth- quake and the nuclear power plant accidents on March 11, 2011, the future energy balance flow for Japan was quantitatively estimated. Cogeneration systems and heat ...

14

Performance of an Activated Carbon Ammonia Adsorption Refrigeration System

Performance of an Activated Carbon Ammonia Adsorption Refrigeration System

... Adsorption refrigeration systems, as one of the promising effective energy con- servation techniques and environmentally friendly applications, have been widely studied since the 1970s due to the oil crisis [1]. In ...

21

Show all 10000 documents...

Related subjects