• No results found

crystalline Si solar cell

Fabrication of 20 19% Efficient Single Crystalline Silicon Solar Cell with Inverted Pyramid Microstructure

Fabrication of 20 19% Efficient Single Crystalline Silicon Solar Cell with Inverted Pyramid Microstructure

... (sc-Si) solar cell has long domi- nated the solar cell market owing to its high photoelectric conversion efficiency and comprehensive performance [1– ...other crystalline and ...

8

An Investigation on a Crystalline Silicon Solar Cell with Black Silicon Layer at the Rear

An Investigation on a Crystalline Silicon Solar Cell with Black Silicon Layer at the Rear

... surface-etched Si that has been loaded or doped with metal or non-metal ions could exhibit strong and broadband absorptivity ...of Si, or black Si (b-Si), has attracted much attention for its ...

6

Flexible carbon nanotube/mono crystalline Si thin film solar cells

Flexible carbon nanotube/mono crystalline Si thin film solar cells

... The Si thin film can be bent to almost 180° by tweezers, showing a good flexible ...the Si films are flexible and bendable when the thickness is less than approximately 50 ...thin-film solar ...

6

Performance analysis of crystalline (poly Si) and thin film (a Si/c Si) 
		photovoltaic systems

Performance analysis of crystalline (poly Si) and thin film (a Si/c Si) photovoltaic systems

... for crystalline silicone cell was 1 when incident radiation was 1 kW/m2 and PV cell temperature was 25°C at outdoor ...the cell temperature was always greater than ...PV cell ...

5

Periodically Aligned Si Nanopillar Arrays as Efficient Antireflection Layers for Solar Cell Applications

Periodically Aligned Si Nanopillar Arrays as Efficient Antireflection Layers for Solar Cell Applications

... on Si sur- face and no SiNP bundles or clumps can be observed on Si surface, implying an effective method to fabricate large- area PASiNP arrays in our ...p-type Si substrate could be pre- vented ...

6

Cross Sectional Investigations on Epitaxial Silicon Solar Cells by Kelvin and Conducting Probe Atomic Force Microscopy: Effect of Illumination

Cross Sectional Investigations on Epitaxial Silicon Solar Cells by Kelvin and Conducting Probe Atomic Force Microscopy: Effect of Illumination

... In Fig. 4, both KPFM and CP-AFM measurements along the cell cross section show that the profiles with and without illumination diverge strongly at the epi-Si/ wafer p ++ interface. Further in the epitaxial ...

8

Effect of Double Layer (SiO2/TiO2) Anti-reflective Coating on Silicon Solar Cells

Effect of Double Layer (SiO2/TiO2) Anti-reflective Coating on Silicon Solar Cells

... as-grown Si solar ...of solar cell were characterized through electrical (AM ...mono- crystalline Si solar cells, compared with ...SLAR Si solar ...

10

Fabrication and Identification of the Efficiency of a Si-Based Solar Cell

Fabrication and Identification of the Efficiency of a Si-Based Solar Cell

... a solar cell which is based on a thin p-type silicon (Si) ...wafer. Solar cells are the basic building blocks of Solar Panels or ...manufacturing solar modules in the ...from ...

7

Effect of Sub Grains and Crystal Defects on Monolike Si Solar Cell Performance

Effect of Sub Grains and Crystal Defects on Monolike Si Solar Cell Performance

... for solar cell ...increase cell efficiency distribution in a production ...single crystalline silicon wafers, and acidic solution for multicrystalline silicon ...

6

Effect of Light intensity and Temperature on Crystalline Silicon Solar Modules Parameters

Effect of Light intensity and Temperature on Crystalline Silicon Solar Modules Parameters

... a solar cell which is a device that converts the sunlight directly into direct current (DC) of electrical energy by the photovoltaic ...various solar module devices, the Si solar module ...

8

Selective emitter using a screen printed etch barrier in crystalline silicon solar cell

Selective emitter using a screen printed etch barrier in crystalline silicon solar cell

... a crystalline silicon (C-Si) solar cell because it is related to the surface recombination vel- ...common solar cell for commercial applications is about 40 to 50 Ω/sq, which is ...

8

Greatly Enhanced Photovoltaic Performance of Crystalline Silicon Solar Cells Using Metal Oxide Layers by Band-Gap Alignment Engineering

Greatly Enhanced Photovoltaic Performance of Crystalline Silicon Solar Cells Using Metal Oxide Layers by Band-Gap Alignment Engineering

... CdO/Si single-layer solar cell (SLSC) and SnO 2 /Si single layer solar cell.. 59.[r] ...

9

Simulation and Optimization Characteristic of Novel MoS2/c Si HIT Solar Cell

Simulation and Optimization Characteristic of Novel MoS2/c Si HIT Solar Cell

... of solar cells include the valence band, the conduc- tion band extension state, the localized states of valence band tail and the loca- lized states of interval ...

16

Effect of Thickness on Boron-Doped Silicon Thin Film Deposited onto Silver-Aluminium Back Contact-Coated Plastic Substrate by Screen Printing

Effect of Thickness on Boron-Doped Silicon Thin Film Deposited onto Silver-Aluminium Back Contact-Coated Plastic Substrate by Screen Printing

... costs, Si thin film solar cells on inexpensive foreign substrates have been studied ...deposited Si thin films onto substrate-coated seed layers with LPE, uniform and continuous Si thin films ...

13

Generation of high photocurrent in three dimensional silicon quantum dot superlattice fabricated by combining bio template and neutral beam etching for quantum dot solar cells

Generation of high photocurrent in three dimensional silicon quantum dot superlattice fabricated by combining bio template and neutral beam etching for quantum dot solar cells

... solution methods and molecular beam epitaxy (MBE)) have convincingly been used to fabricate relatively uni- form quantum dots; however, very few technologies can finitely arrange QDs to form a quasi-crystal structure. ...

7

Analysis of Effects Resulted from Changing the Buffer Layer Material on Optimization of Cu (In 1-x,Gax) Se2 Thin Filmsolar cell(CIGS) and Simulation of Cell Structure

Analysis of Effects Resulted from Changing the Buffer Layer Material on Optimization of Cu (In 1-x,Gax) Se2 Thin Filmsolar cell(CIGS) and Simulation of Cell Structure

... 3, solar cell efficiency with ZnMg buffer layer has decreased about 2% in comparison with solar cell efficiency with Cds buffer ...in solar cells, as a result it can be a sufficient ...

5

Probing the structure property composition relationship in organic inorganic tri halide perovskites

Probing the structure property composition relationship in organic inorganic tri halide perovskites

... tandem solar cell with Si, and this offers the possibility of achieving power conversion efficiencies above the Schockley Queisser limit for a single junction solar ...

17

Comparative analysis of solar 
		refrigeration system with polycrystalline solar panel and thin film

Comparative analysis of solar refrigeration system with polycrystalline solar panel and thin film

... different solar panel. The solar panels are poly crystalline solar technologies and thin film technologies, because these solar panels have different ...as solar power, wind ...

5

Enhanced Physical Properties Of Indium Tin Oxide Films Grown on Zinc Oxide-Coated Substrates

Enhanced Physical Properties Of Indium Tin Oxide Films Grown on Zinc Oxide-Coated Substrates

... The substrates used in this study were micro slide glass, p-type (100) c-Si, and textured mc-Si with thicknesses of about 150 µm, 500 µm, and 300 µm, respectively. All substrates were degreased and cleaned ...

9

Design High Efficiency III–V Nanowire/Si Two Junction Solar Cell

Design High Efficiency III–V Nanowire/Si Two Junction Solar Cell

... Multi-junction solar cells are constituted by series-connected multiple semiconductor layers (subcells) to convert the energy of light directly into electricity by the photovol- taic ...broad solar spectrum ...

5

Show all 10000 documents...

Related subjects