Inlet velocity
Effects Of Inlet Velocity On Fluid Flow In T-Junction Pipe For Combining Flow
... various inlet in pipe with minimal pressure loss and best inlet velocity? Then, how to simulate the part model of fluid flow through T-junction by using HyperWorks simulation software according to ...
24
Effect of Inlet Velocity on the Crude Oil Coking and Gas Phase Formation in a Straight Pipe
... as velocity getting higher, this streamline behavior ...liquid velocity near the centerline exceeds the inlet velocity, pressure increase induced by gas phase is expected to speed up the ...
9
DETERMINATION OF PRESSURE DROP ACROSS A RANGE OF INLET VELOCITY IN A STAIRMAND’S HIGH EFFICIENCY CYCLONE
... Inlet velocity obtained for selected speeds was between ...for velocity and pressure profiles on no-load and load basis were both represented by third order polynomial functions of differing ...
14
Effect Of Inlet Velocity On Fluid Flow In T-Junction Pipe With Edge Fillet For Dividing Flow
... Peng et.al (1994) conducted a study of dividing steam and water flow in T- Junction. In this study also provide detailed experimental data of phase redistribution and associated pressure changes in T-junctions having ...
24
Heat Transfer Based Numerical Investigation of Aircraft Cabin Environment from Various Inlet Conditions
... shows inlet flow rate increase with the inlet velocity increasing and more energy will be consumed to produce the required flow ...the inlet flow increases, as shown in Figure ...air ...
8
CFD ANALYSIS OF TANGENTIAL VELOCITY IN SINGLE INLET CYCLONE SEPARATOR IN INDUSTRY BY USING ANSYS SOFTWARE
... both inlet cyclone 30 degree and inlet cyclone 45 degree separator under the same condition of inlet velocity, flow rate and particle ...tangential inlet cyclone 30° degree Turbulence ...
9
Electrochemical Hydrodynamics Modeling Approach for a Copper Electrowinning Cell
... Figure 9 shows a comparison of the local current density between the simulation and approximation from the diffusion boundary layer thickness for an applied current density of 100 A/m 2 and inlet velocity ...
15
Effects of Inlet Parameters on the Performance of Bluff Body Combustion
... the inlet velocity, equivalence ratio and bluff body shape on the combustion efficiency (in terms of mass fraction of CO 2 ) and exhaust gas temperature were ...
9
Nozzle Design Optimization to Reduce Noise
... Figure 14: Acoustic Power Level For the chevron nozzle, at the inlet velocity, 3.5m/s, the maximum velocity obtained at the exit is 10.3m/s.. this indicates that as the area decreases ve[r] ...
9
Design of Air Distribution System for Operation Theatre Using Flow Visualization Techniques to Improve Flow Characteristics
... varying inlet diffuser angle, constant 0.4m/s inlet velocity and air flow pattern are investigated with the help of numerical simulation and experimental setup of prototype OT ...
6
Influence of the turbulence representation at the inlet on the downstream flow pattern in LES of backward-facing step
... of inlet boundary condition treatment on the fluid flow is studied in this ...the inlet to the domain is essential for the accuracy of Large Eddy ...the inlet velocity has significant effect on ...
5
Effect of Geometric Configuration on Performance of Uniflow Cyclone
... angles, inlet velocities, Outlet to Inlet diameters ratio, separation ...drop. Inlet velocity is measured with an anemometer at the entrance of ...
7
Simulation of Secondary Flow in Lubrication Pipe with End Bends of an Aero Engine
... the velocity and pressure variations have been plotted in figure 7 and figure ...The inlet velocity is 1.45 m/sec. The figure 7 shows that the velocity is maximum at the entrance region and it ...
6
Research on the Transfer Characteristics of the Micro Particle in a Corrugated Pipe
... Abstract: The corrugated pipe is widely used in figure heat exchangers. For the reason of large temperature difference between the gas in the pipe and the cold wall, particles may deposit on the wall, and make some ...
9
A novel experimental method to assess particle deposition in idealized porous channels
... of inlet velocity, inertial impaction (particle bounce) is profound at the front face of any obstruction (leading edge) adjacent to the ...the inlet than any other ...the inlet together with a ...
28
Analysis of Flow Through Rotameter Using CFD
... the inlet velocity corresponding to that location is specified and the drag force on the float is ...the inlet velocity is changed accordingly so that drag force achieves this ...that ...
8
ANALYSIS OF COMBUSTION CHARACTERISTICS OF METHANE/AIR MIXTURE IN COAXIAL COMBUSTOR
... ratio, inlet temperature of the air-fuel and inlet velocity of the air-fuel on flame characteristics and finally investigate the species concentration and temperature distribution within the chamber ...
9
Improvement of Liquid Film Width Prediction Model with Two-dimensional Film Flow Experiment
... acquired inlet velocity conditions from modified linear scaling method were already validated with several scaled test geometry, these 1/10 scaled inlet conditions can be assured to yield valid ...
9
CFD modelling of a pump intake
... CFD offers a tool that the engineer can utilise to test and refine the design of a pump sump or intake structure. The use of CFD modelling in conjunction with physical modelling has the potential to reduce the total cost ...
49
Experimental study and comparison of different geometric configurations in the reactive gases feeding of a PEMFC
... gas velocity profiles, comparing between concurrent or countercurrent flow modes, exhibited some minor ...between inlet and outlet, which indicated that the drag induced by the flux of water within the EME ...
20