• No results found

mixing and separation

Blind Separation of Nonlinear Mixing Signals Using Kernel with Slow Feature Analysis

Blind Separation of Nonlinear Mixing Signals Using Kernel with Slow Feature Analysis

... Where f is an unknown vector of real functions. The linear instantaneous mixing (BSS) can be solved by using independent component analysis (ICA) [4]. The goal of the ICA is to separate the signals by finding ...

6

Blind Separation of Post-nonlinear Mixing Signals based on B-spline Neural Network and QR Factorization

Blind Separation of Post-nonlinear Mixing Signals based on B-spline Neural Network and QR Factorization

... Different approaches have been used for PNL-BSS. In [8], their separation structure is a two-stage system, namely a nonlinear stage followed by a linear stage. The parameters of these stages are obtained through ...

16

A Trial of Using Solvent Extraction for Phosphorus Recovery

A Trial of Using Solvent Extraction for Phosphorus Recovery

... and separation time): In order to determine the best mixing time, a volume (mL) of the extractant (benzyldimethylamine + kerosene) and model water containing known phosphate concentration, at a phase ratio ...

9

Blind Audio Source Separation (Bass): An Unsuperwised ApproachNaveen Dubey, Rajesh Mehra

Blind Audio Source Separation (Bass): An Unsuperwised ApproachNaveen Dubey, Rajesh Mehra

... Source Separation is being done by FastICA and Convex divergence ICA for determined mixture in which three source signals are recorded by three microphone ...ideal mixing model was considered due that ...

5

The Application of Biosurfactant Produced by Azotobacter sp. for Oil Recovery and Reducing the Hydrocarbon Loading in Bioremediation Process

The Application of Biosurfactant Produced by Azotobacter sp. for Oil Recovery and Reducing the Hydrocarbon Loading in Bioremediation Process

... The separated phase formed after mixing biosurfactant and oil sludge were shown on Fig. 5. The recovered oil was found at 140 ml for ratio 3:1, 130 ml for ratio 2:1 and 64 ml for ratio 1:1. The highest oil ...

5

Simulative Comparative Analysis of Blind Source Separation Algorithms

Simulative Comparative Analysis of Blind Source Separation Algorithms

... source separation (BSS), multiple independent source signals are extracted from their mixtures with little or no knowledge about the sources and the mixing ...the mixing matrix and demixing matrix ...

6

Batch Separation of Styrene/Ethyl Benzene/Water Dispersions

Batch Separation of Styrene/Ethyl Benzene/Water Dispersions

... The separation of immiscible liquids is an important process in oil and petrochemical ...batch separation of ethyl benzene and styrene from ...various mixing rates. The experiments show that the ...

7

Multiresolution Subband Blind Source Separation: Models and Methods

Multiresolution Subband Blind Source Separation: Models and Methods

... the mixing process on the resultant mixtures, which can be exploited to make estimating the mixing process much ...source separation in the case when there are more sources than ...

8

System Integration - A Major Step toward Lab on a Chip

System Integration - A Major Step toward Lab on a Chip

... and mixing can be achieved and a flow rate of over 1 μL/min has been achieved with a low gate voltage ...the separation between the charged particle and the mobile ions in the double ...gical ...

22

Synthesis, Characterization and DC Conductivity of PANI/ZnFe2O4 Composites

Synthesis, Characterization and DC Conductivity of PANI/ZnFe2O4 Composites

... on mixing aqueous solutions of aniline hydrochloride and ammonium persulphate at room temperature, followed by the separation of polyaniline hydrochloride precipitate by filtration and ...

10

Stability Bounds for Stationary φ-mixing and β-mixing Processes

Stability Bounds for Stationary φ-mixing and β-mixing Processes

... We also illustrate the application of our ϕ-mixing generalization bounds to general classes of learning algorithms, including Support Vector Regression (SVR) (Vapnik, 1998), Kernel Ridge Re- gression (Saunders et ...

26

Advances in mixing technology: recent advances in mixing research and development

Advances in mixing technology: recent advances in mixing research and development

... fluid mixing: static mixer, micromixer, unsteady agitation, eccentric agitation, and so ...on mixing has been strongly ...on mixing fundamental (2 papers), multiphase mixing (3 papers), ...

136

Dye removal and separation efficiency of cyanex 301from the dye mixture

Dye removal and separation efficiency of cyanex 301from the dye mixture

... Various solvents such as chloroform, xylene, toluene, n- hexane, dichloromethane, ethylacetate and diethyl ether were tried for the extraction study. Among them, chloroform and dichloromethane extracted the dyes ...

6

Modelling the diurnal cycle of tropical convection across the ‘grey zone’

Modelling the diurnal cycle of tropical convection across the ‘grey zone’

... We present the results of simulations carried out with the Met Office Unified Model at 12 km, 4 km and 1.5 km resolution for a large region centred on West Africa using several different representations of the convection ...

10

Study The Homogeneity of Mixing a Binary Polyethylene Granular Mixture in Fluidised Bed Mixer

Study The Homogeneity of Mixing a Binary Polyethylene Granular Mixture in Fluidised Bed Mixer

... suggests that the degree of mixing achievable at this condition vary with gas velocity. This was due to the lack of bubbles under this condition, which was evident from analysis of snapshots. Results observed in ...

5

Heats of mixing

Heats of mixing

... If it is assumed that the molecules are constructed of tho ele;nents CH;1= and CII3 -, occupying a lattice with eoordination n:u:aber · z ~ 3, then the mol.ar heat of mixing should be gi[r] ...

63

Recognizing location of graphical and text for restoration after  separation and compression in pdf documents

Recognizing location of graphical and text for restoration after separation and compression in pdf documents

... Optical Character Recognition (OCR) (Ramiah et al 2015) is widely used for text recognition process. The OCR algorithm depends on the successful separation of text and graphical part of the PDF document. The task ...

6

A methodology for design of lightweight robotic arm links in harsh environments

A methodology for design of lightweight robotic arm links in harsh environments

... suitable structure must be chosen. This depends on the loading conditions of the arm link. The first of the constraints to ensure consistent quality manufacture is also implemented here – the minimum feature dimension ...

10

Mixing of the Immiscible Liquids in the Entrance Region of a T-Type Chamber Using Laser Induced Fluorescence (LIF) Method

Mixing of the Immiscible Liquids in the Entrance Region of a T-Type Chamber Using Laser Induced Fluorescence (LIF) Method

... [1]. Mixing is also important in advancing both heat and mass transfer in ...of mixing of materials greatly determines the success and efficiency of many industrial processes, while ineffective ...

11

Characterization of Fusion Determinants Points to the Involvement of Three Discrete Regions of Both E1 and E2 Glycoproteins in the Membrane Fusion Process of Hepatitis C Virus

Characterization of Fusion Determinants Points to the Involvement of Three Discrete Regions of Both E1 and E2 Glycoproteins in the Membrane Fusion Process of Hepatitis C Virus

... whereas the nonconservative G418D substitution displayed a block at the stage of hemifusion in content mixing assays (Fig. 6, panels b and h). The discrepancy between the behavior of G418A and G418D mutants ...

14

Show all 10000 documents...

Related subjects