Optical Microscope
A simple but precise method for quantitative measurement of the quality of the laser focus in a scanning optical microscope
... an optical bench (Firester et ...scanning microscope is not trivial because of the limited accessibility to the laser beam exiting the ...an optical microscope using reflection imaging, but ...
8
Development of a controlled environment near-field optical microscope for organic thin film studies
... a microscope differ greatly from field to field and with the sample being ...field optical microscope suit- able for environmentally controlled ...better optical characterization of thin films ...
9
PREPARATION AND EVALUATION OF CIPROFLOXACIN DRY EMULSION CONTAINING SUSTAINED RELEASE BEADS BY IONTOPHORETIC GELLATION METHODPatil Bhagyashree Subhash*, M.A.Bhutkar,Tina Raju,Tanushree Sarkar, Dr. S. K. MohiteDOWNLOAD/VIEW
... The objective of the current investigation is to reduce dosing frequency and improve patient compliance by designing and systematically evaluating sustained release micro beads of Ciprofloxacin. Method: Ciprofloxacin- ...
7
The Surface Properties of Plastic Mold Steel Subjected to Nitriding Treatment
... an optical microscope was used to analyze the microstructure and thickness of the nitride layer, X-ray diffraction (XRD) was performed to examine the structure, a 3D surface pro fi le meter was employed to ...
6
Dual Monitoring of Cracking and Healing in Self-healing Coatings using Microcapsules Loaded with Two Fluorescent Dyes
... (a) Dye-loaded microcapsules and chemical structure of healing agents and fluorescence dyes, SEM and optical microscope images of microcapsules before and after pho[r] ...
15
Super Resolution Microscopy of Lipid Bilayer Phases and Single Molecule Kinetic Studies on Merocyanine 540 Bound Lipid Vesicles.
... an optical microscope, we further looked into the kinetics of MC540 monomer dimer equilibrium in lipid bilayers using single molecule intensity time trajectory analysis and polarization dependent ...
128
Microscopic and Elemental Mapping of InSbBi Substrate of Bulk Crystal Grown by VDS
... Among the III-V semiconductors, bulk crystal of InSbBi is the most studied material because, its energy gap can be reduced (below 0.17eV) by adjusting their compositional ratio, to extend the wavelength range beyond 7.2 ...
5
Behaviors and Characteristics Study of the Electron Beam for Lens System in a Scanning Electron Microscope
... the optical microscope, we use accelerated electrons of extremely short wavelength less than ...While optical microscope use a visible light source in the range of 300– 700nm wavelength, a SEM ...
12
Comparison of marginal fit of cemented zirconia copings manufactured after digital impression with lava™ C.O.S and conventional impression technique
... It is difficult to compare the results of this study with recent literature due to differences in measuring tech- niques and measuring parameters used for the evalu- ation of fit of fixed dental restorations. An in vivo ...
8
DEVELOPMENT AND CHARACTERIZATION OF LOVASTATIN LOADED MICROSPHERES
... v) Determination of Particle Size of microspheres: The particle size of the microspheres was determined by using an Optical microscope. The microspheres were examined by opti[r] ...
8
Transmission Electron Microscopy Preparation and Characterization of Bulk ZnO and Au(111) / ZnO(000-1) Heterostructures
... Cracking of samples during thinning to achieve materials for TEM investigations due to microporosity in the material must be completely avoided. The use of the repeat dimple method described in Chapter 2 as the ...
96
Imaging for Minimally Invasive Surgery
... the optical microscope video stream, the neu- ro-navigation view (reslices of the pre-operative MRI data aligned to the patient), intra-operative ultrasound 3D volumes and overview image of the operating ...
9
Enamel Insulated Copper Wire in Electric Motors: Sliding Behavior and Possible Damage Mechanisms During Die Bending
... Scratch testing of the enamel surfaces with a varying load shows the changes in the COF with respect to the applied load. The two scratch tests were performed at loads 0.03N to 1.0N and 0.03N to 3.7N. In both cases, the ...
274
Image Analysis to Detect Phase Transition Temperatures of p–n Alkyl benzoic acids
... For visualizing and recording the textures as a function of temperature, Meopta polarizing optical microscope with hot stage [14] and camera is used in the arthroscopic mode [10]. A commercially available ...
7
The Influence of Microstructure of Arc Sprayed Coatings on Wear Resistance
... Microstructure investigations revealed nu- merous cracks between the coating and the base material, as well as in the top layer of the coating. The pores observed between the coating and the substrate could have a ...
8
Intelligent Recognition for Microbiologically Influenced Corrosion Based On Hilbert-huang Transform and BP Neural Network
... signal on the measurement system. It does not interfere with microbial growth and reproduction, thus, electrochemical noise measurement method is very suitable for microbial-induced corrosion[4]. Electrochemical noise ...
9
Terahertz Nanoscopy of Plasmonic Resonances with a Quantum Cascade Laser
... scattering optical microscope (s-SNOM) operating in the terahertz frequency range based on resonant quartz tuning forks and on quantum cascade ...The microscope achieved a spatial resolution of > ...
9
Formation of Fe-Ni composite on pure aluminum substrate by laser surface alloying
... sec). The greatest time was mentioned at 50 seconds of laser exposed. After laser alloying process, the samples were cut into lengthways and prepared for microstructure and metallographic observation by using scanning ...
6
Optical super resolution through super oscillations
... We demonstrate that a quasi-periodic array of nano-holes in a metal screen can focus light into subwavelength spots in the far field without contributions from evanescent fields. The subwavelength spots were observed ...
8
Sensitivity of Black Phosphorus to O2 and Atmosphere Measured by Macroscopic Four-Point Probe
... in air (experiment 4). For each of the experiments, the overall procedure was nearly identical: first, we landed the home-built probe on cleaved bulk BP by using the optical microscope and the procedure ...
30