• No results found

PEM fuel cell modeling

NEURAL NETWORK BASED PEM FUEL CELL MODELING FOR ELECTRIC VEHICULAR APPLICATION

NEURAL NETWORK BASED PEM FUEL CELL MODELING FOR ELECTRIC VEHICULAR APPLICATION

... In this paper, application of ANN is used to predict the stack voltage of PEM fuel cells. In this analysis, two parameters namely stack current and stack temperature were used as input to the network with ...

10

Component based modeling of PEM fuel cells with bond graphs

Component based modeling of PEM fuel cells with bond graphs

... the cell layers ...the fuel cell for optimised ...the fuel cell system including the thermal and water ...a fuel cell as separate ...

16

CFD modeling and simulation of PEM fuel cell using OpenFOAM

CFD modeling and simulation of PEM fuel cell using OpenFOAM

... (PEM) fuel cell is an electrolytic cell that converts chemical energy of hydrogen reacting with oxygen into electrical ...a PEM fuel cell is ...the cell working ...

6

Water Management in the Cathode Side of a PEM Fuel Cell

Water Management in the Cathode Side of a PEM Fuel Cell

... performance modeling of a PEMFC. At high cell current densities, excessive water transport throughout the membrane and water production in the cathode catalyst layer result in mass transport limitations and ...

8

Water and thermal management in a single PEM fuel cell.

Water and thermal management in a single PEM fuel cell.

... developed PEM fuel cell models that are based on both the theoretical mechanistic analysis and empirical ...doing fuel cell modeling for many years and have made very impressive ...

119

Scaling up study of PEM fuel cell for performance enhancement

Scaling up study of PEM fuel cell for performance enhancement

... good mesh has been one of the most difficult steps involved in modeling. It requires a careful balance of creating enough computational cells to capture the geometry without creating much of its care should be ...

6

The Use of LMS AMESim in the Fault Diagnosis of a Commercial PEM Fuel Cell System

The Use of LMS AMESim in the Fault Diagnosis of a Commercial PEM Fuel Cell System

... active cell area, membrane length, volumes of cathode and anode chambers, mass of stack, ...alternative modeling platform since all the common PEMFC modeling equations available in literature [2, 3] ...

13

Contents DURABILITY OF PEM FUEL CELL MEMBRANES. Xinyu Huang and Ken Reifsnider

Contents DURABILITY OF PEM FUEL CELL MEMBRANES. Xinyu Huang and Ken Reifsnider

... Chapter 9 ATOMISTIC MODELING IN STUDY OF POLYMER ELECTROLYTE FUEL CELLS – A REVIEW Xiangyang Zhou, Juanjuan Zhou, and Yijin Yin 1. Fundamentals of Atomistic Modeling[r] ...

7

Dynamic Modeling and Fractional Order PIλDμ Control of PEM Fuel Cell

Dynamic Modeling and Fractional Order PIλDμ Control of PEM Fuel Cell

... the cell structure and controlling the ...of fuel cell research has become a hot topic in this ...of cell by CFD ...the cell performance by the function current ...

19

Modeling and analysis of proton exchange membrane (PEM) fuel cell

Modeling and analysis of proton exchange membrane (PEM) fuel cell

... other fuel cell PEM fuel cell also involves mainly three parts namely Anode, Cathode and Electrolyte also termed as the ...The PEM fuel cell has wide application in ...

6

Effect of temperature on the in-plane permeability of the gas diffusion layer of a PEM fuel cell

Effect of temperature on the in-plane permeability of the gas diffusion layer of a PEM fuel cell

... Pharoah [14] concluded that the in-plane permeability plays a much more prominent role in fuel cell mass transport compared to the through-plane permeability. In his study, he varied the value of ...

73

Experimental Testing and Validation of the Mathematical Model for a Self Humidifying PEM Fuel Cell

Experimental Testing and Validation of the Mathematical Model for a Self Humidifying PEM Fuel Cell

... self-humidifying PEM fuel cell is devel- oped by modelling the major electric and thermodynamic variables and pa- rameters, as it was mathematically modelled and presented in the recent pub- lished ...

17

Preparation, characterization and comparative study of gas diffusion layer for pem fuel cell

Preparation, characterization and comparative study of gas diffusion layer for pem fuel cell

... membrane fuel cell (PEMFC) stack, the gas diffusion media is sandwiched between the bipolar plate and the catalyst layer to form the gas diffusion layer mass transport losses which cause overvoltage due to ...

8

Experimental testing and validation of the mathematical model for a self humidifying PEM fuel cell

Experimental testing and validation of the mathematical model for a self humidifying PEM fuel cell

... Horizon fuel cell stack are measured and drawn in Figure ...Horizon fuel cell stack under the impact of constant drawn current is almost stable around ...Horizon PEM fuel ...

18

Enhancement of the Cooling System Performance of the Proton-exchange Membrane Fuel Cell By Baffle-restricted Coolant Flow Channels

Enhancement of the Cooling System Performance of the Proton-exchange Membrane Fuel Cell By Baffle-restricted Coolant Flow Channels

... membrane fuel cell cooling system using coolant flow channels enhanced with baffles was numerically ...the fuel cell in such a way that a reduced maximum temperature of the cell and a ...

8

A review on performance improvement of flow field design for PEM fuel cell

A review on performance improvement of flow field design for PEM fuel cell

... for fuel gets ...problem, fuel cell is ...of PEM fuel cell based on several forms such as water management, design parameter, channel ...In PEM fuel cell the ...

5

Assessment of Various Parameters of Low Temperature PEM Fuel Cell Components

Assessment of Various Parameters of Low Temperature PEM Fuel Cell Components

... 1. It has been investigated that by using metallic materials, e.g., copper, aluminum, stainless steel and gold- quately addressed. It was found that pure graphplatted copper, some of the required properties are ...

10

PEM Fuel Cell Drying and Flooding Diagnosis With Signals Injected by a Power Converter

PEM Fuel Cell Drying and Flooding Diagnosis With Signals Injected by a Power Converter

... the cell impedance practically reduces to the ohmic ...single PEM FC, show- ing that quite accurate measurements of the ohmic resistance can be obtained if suitable model-based elaboration algorithms are ...

8

Analysis and Compensation of PEM Fuel Cell Instabilities in Low-Frequency EIS Measurements

Analysis and Compensation of PEM Fuel Cell Instabilities in Low-Frequency EIS Measurements

... Unfortunately, however, in several cases the equilibrium reached by the FC after all transients associated with relaxation phenomena have ended is not stable and significant variations of the cell internal ...

8

PEM-Proton Exchange Membrane Fuel Cell Emulator Based on Buck Converter

PEM-Proton Exchange Membrane Fuel Cell Emulator Based on Buck Converter

... A fuel cell is an electrochemical device that converts chemical energy of a reaction directly into the electrical ...membrane. Fuel Cell (FC) produces electricity, water and heat from an ...

9

Show all 10000 documents...

Related subjects