• No results found

silicon-on-insulator structures

Graphene as a buffer layer for silicon carbide-on-insulator structures

Graphene as a buffer layer for silicon carbide-on-insulator structures

... of silicon large-scale integrated circuits (Si-LSIs) has been enhanced over the last 30 years by increasing the number of transistors in accordance with Moore’s law ...

10

Optimizing band edge slow light in silicon on insulator waveguide gratings

Optimizing band edge slow light in silicon on insulator waveguide gratings

... such structures is that they are easy to produce with the fabrication techniques for silicon based PICs, propagation losses are low as they operate below the cladding light line, and insertion losses can be ...

9

Optical Biosensors based on Silicon-On-Insulator Ring Resonator: A Review

Optical Biosensors based on Silicon-On-Insulator Ring Resonator: A Review

... planar silicon ring resonators with innovative guiding structures have been theoretically investigated ...resonator structures show ring resonator sensitivities of up to 120 nm/RIU and high Q-factors ...

14

Design And Characterization Of Silicon-On-Insulator (SOI) Metal - Oxide- Semiconductor Field Effect Transistor (MOSFET)

Design And Characterization Of Silicon-On-Insulator (SOI) Metal - Oxide- Semiconductor Field Effect Transistor (MOSFET)

... device structures (DEVEDIT) and investigating the overall device performances based on device characteristics that have been extracted from the device simulation (ATLAS) ...

24

Free-carrier effects in polycrystalline silicon-on-insulator photonic devices

Free-carrier effects in polycrystalline silicon-on-insulator photonic devices

... waveguide structures used in this thesis work were produced from a photolithography mask that was not fully optimized for polycrystalline silicon, single-mode ...photonic structures and only a few ...

91

Ultra low silicon substrate noise crosstalk using metal Faraday cages in a silicon on insulator technology

Ultra low silicon substrate noise crosstalk using metal Faraday cages in a silicon on insulator technology

... Four types or configurations of the SOI structure were fabri- cated. In the first configuration (config #1) the Faraday cage was omitted (including the buried metal ground plane, metal-lined trenches, and layers beneath ...

6

Three Dimensional Numerical Simulation and Modeling of Small Geometry Fully Depleted SOI MOSFET

Three Dimensional Numerical Simulation and Modeling of Small Geometry Fully Depleted SOI MOSFET

... on silicon-on-insulator (SOI) wafers are gaining prominence in present-day very large-scale integration (VLSI) ...device structures; three-dimensional (3D) models are necessary to address the ...

6

Partially Depleted Silicon on Insulator Phase Lock Loop

Partially Depleted Silicon on Insulator Phase Lock Loop

... structures than previously fabricated. In an effort to use these devices for characterization and to avoid fabricating an additional set of test structures, it was decided to see if the current data could ...

92

A Study on the Impact of Silicon-on-Nothing (SON) Versus Silicon-on-Insulator (SOI) on the Electrostatic Performance of a Transistor 

A Study on the Impact of Silicon-on-Nothing (SON) Versus Silicon-on-Insulator (SOI) on the Electrostatic Performance of a Transistor 

... [7] V. Kilchytska, D. Levacq, D. Lederer, G. Pailloncy, J. Raskin & D. Flandre, “Substrate Effect on the Output Conductance Frequency Response of SOI MSOFETs,” in Nanoscaled Semiconductor-on-Insulator ...

6

One Dimensional Multi Channel Photonic Crystal Resonators Based on Silicon On Insulator With High Quality Factor

One Dimensional Multi Channel Photonic Crystal Resonators Based on Silicon On Insulator With High Quality Factor

... Prototype devices were fabricated with three central cavities infiltrated with LC E7. Simulations of the electro-optical and optical properties of these devices were confirmed experimentally using polarized optical ...

9

The fabrication and analysis of hard Si3N4 based, dispersed phase composites

The fabrication and analysis of hard Si3N4 based, dispersed phase composites

... usual silicon carbide grinding pads were not used for any stage of the grinding or polishing operations, but successively finer grades of diamond-containing slurries (oil or water based) were used with a cast iron ...

210

Study of low dimensional SiGe island on Si for potential visible Metal-Semiconductor-Metal photodetector

Study of low dimensional SiGe island on Si for potential visible Metal-Semiconductor-Metal photodetector

... The band gap for the SiGe islands and the bulk Ge were extracted from the simulation as shown in Fig. 6. It can be seen that altering the island sizes has no cause to the changes in the band gap of the SiGe ...

6

Investigation of the Influence of Hydrophobicity and Dry Band on the Electric Field and Potential Distributions in Silicon Rubber Insulator

Investigation of the Influence of Hydrophobicity and Dry Band on the Electric Field and Potential Distributions in Silicon Rubber Insulator

... In this part the simulation results for clean and polluted condition is presented. The results illustrate the effect of pollution and hydrophobicity degree and the location of dry bands on silicon rubber ...

7

Optical biosensors for mycotoxin detection in milk

Optical biosensors for mycotoxin detection in milk

... Finally, to complete the overview of optical label-free biosensors, we must mention optical fiber based sensors. Thanks to their small size, flexibility, me- chanical robustness, mature fabrication techniques and their ...

163

Single waveguide silicon-organic hybrid modulator

Single waveguide silicon-organic hybrid modulator

... In the last decades, the integration and parallelization of electro-optic modulators in combination with higher order modulating schemes led to data rates up to 54 Tbit s −1 trans- mitted over a single core fiber and a ...

7

Thin Film Silicon-On-Insulator of Bipolar Junction Transistor: Process Fabrication and characterization Technology.

Thin Film Silicon-On-Insulator of Bipolar Junction Transistor: Process Fabrication and characterization Technology.

... impurities profile is determined by strongly interdependent process parameters such as surface concentration, diffusion temperature time, and surface preparation, ultra-shallow junction formation is still difficult. In ...

10

IMPLEMENTATION OF LINEAR CURRENT MODULATION FOR LED DRIVER IC Anju Kuhar*1, Himanshi Saini2

IMPLEMENTATION OF LINEAR CURRENT MODULATION FOR LED DRIVER IC Anju Kuhar*1, Himanshi Saini2

... underlying silicon-on-insulator technology is to remedy this by electrically insulating the thin layer at the wafer surface carrying the electronic devices from the bulk wafer used as mechanical ...the ...

14

Electric field study of silicon rubber insulator using finite element method (SLIM)

Electric field study of silicon rubber insulator using finite element method (SLIM)

... The main objective of this project is to carry out a study on the electric field distribution of energized silicon rubber insulator under clean and contaminated condition using finite el[r] ...

24

Active Body Bias for Low-Power Silicon-On-Insulator Design

Active Body Bias for Low-Power Silicon-On-Insulator Design

... implanted hydrogen produces cavities in the silicon lattice at the implant range. If the wafer were annealed at this point, the implanted hydrogen would form molecular hydrogen and pressure would build inside the ...

144

Electrical behavior of MIS devices based on Si nanoclusters embedded in SiOx
              Ny
              and SiO2 films

Electrical behavior of MIS devices based on Si nanoclusters embedded in SiOx Ny and SiO2 films

... of silicon oxynitride with embedded silicon nanoclusters has been validated in order to achieve diode with high rectifying ...of silicon oxide matrix and silicon nanoclusters and (2) to act as ...

6

Show all 10000 documents...

Related subjects