• No results found

uniform thickness

Stress Analysis of Non-Uniform Thickness Piping System with General Piping Analysis Software

Stress Analysis of Non-Uniform Thickness Piping System with General Piping Analysis Software

... with uniform pipe wall thickness. However, non-uniform wall thickness, commonly on elbows or bends, can be found in many industrial ...non-uniform thickness caused by flow ...

8

Cataract Detection

Cataract Detection

... that Uniform thickness disk has a little high radial displacement as compared to variable ...thickness. Thickness of the disk has a very little effect on the radial ...for uniform ...

8

Mapping and measuring lava volumes from 2002 to 2009 at El Reventador Volcano, Ecuador, from field measurements and satellite remote sensing

Mapping and measuring lava volumes from 2002 to 2009 at El Reventador Volcano, Ecuador, from field measurements and satellite remote sensing

... lava thickness measurements We checked our identification of flow boundaries during two field campaigns to the northern (June, 2012) and southern (September, 2012) parts of El Reventador cal- ...flow. ...

11

The energetics of the breakup of a sheet and of a rivulet on a vertical substrate in the presence of a uniform surface shear stress

The energetics of the breakup of a sheet and of a rivulet on a vertical substrate in the presence of a uniform surface shear stress

... of uniform thickness into a periodic array of infinitely many identical thin rivulets and of a single thin rivulet into one or more identical sub-rivulets of a non-perfectly-wetting fluid on a vertical ...

40

THE EFFECT OF PROCESS PARAMETERS ON THICKNESS DISTRIBUTION IN THERMOFORMING

THE EFFECT OF PROCESS PARAMETERS ON THICKNESS DISTRIBUTION IN THERMOFORMING

... in thickness. The effect of plug assist on thickness distribution was ...Then thickness distributions on thermoformed products were obtained for two experi- mental procedures by a digital caliper ...

7

Investigating the Effects of Cold Bulge Forming Speed on Thickness Variation and Mechanical Properties of Aluminum Alloys: Experimental and Numerical

Investigating the Effects of Cold Bulge Forming Speed on Thickness Variation and Mechanical Properties of Aluminum Alloys: Experimental and Numerical

... and thickness variations of Al-Mg sheet are evaluated before and after the forming ...maximum thickness reduction of Al- Mg blank is less than 6% after cold bulge ...blank thickness variation for ...

7

The Brazilian disc test under a non-uniform contact pressure along its thickness

The Brazilian disc test under a non-uniform contact pressure along its thickness

... the thickness on the Brazilian result, the distribution of the load is assumed parabolic along the z-direction, but uniform on its ...non-uniform thickness loading ...

8

Large Amplitude Vibrations   of Elasto-plastic Plates and Shells (J397)

Large Amplitude Vibrations of Elasto-plastic Plates and Shells (J397)

... with uniform thickness and mostly in static ...of uniform elasto plastic plates and shells under both static and dynamic loads using the method of constant deflection contour lines and the results ...

6

Uniform mechanical wet grain unloading system

Uniform mechanical wet grain unloading system

... relatively uniform thickness from a wet grain ...relatively uniform thickness is removed from the area immediately above the floor and discharged from the grain container for further ...

6

The Karush–Kuhn–Tucker optimality conditions in minimum weight design of elastic rotating disks with variable thickness and density   Pages 765-774
		 Download PDF

The Karush–Kuhn–Tucker optimality conditions in minimum weight design of elastic rotating disks with variable thickness and density Pages 765-774 Download PDF

... This is the differential equation governing on rotating disks in elastic form. In this research we have to use the results of the pervious works by the authors (Hojjati & Jafari, 2008; Hojjati & Jafari, 2009) for ...

10

Cataract Detection

Cataract Detection

... The objective of the current work is to analyze displacement, stress and strain of uniform thickness rotating annular disk by finite element method. The disk is made up of functionally graded material ...

7

Zone thermal recrystallization of thin 
		layers from a discrete source

Zone thermal recrystallization of thin layers from a discrete source

... thin uniform layers onto a large semiconductor ...obtain uniform thickness layers by the proposed technique it is strongly necessary that the distance between the discrete source and the substrate ...

5

Neurovascular Modeling: Small Batch Manufacturing of Silicone Vascular Replicas

Neurovascular Modeling: Small Batch Manufacturing of Silicone Vascular Replicas

... The described technique provides an efficient method for representative replica construction. However, there are tech- nical difficulties that might be encountered while preparing the silicone models. Bubble formation ...

6

“Fabrication and Characterization of Glibenclamide Transdermal Patches” by Pallavi Vadlamudi, G. V. Radha, Rama Rao Nadendla, India.

“Fabrication and Characterization of Glibenclamide Transdermal Patches” by Pallavi Vadlamudi, G. V. Radha, Rama Rao Nadendla, India.

... properties Thickness, folding endurance and drug content were found to be uniform and reproducible with low SD values compared to patches with hydrophillic and hydrophobic polymers ...

5

Self healing of
composite material
with an intermediate
supramolecular
layer

Self healing of composite material with an intermediate supramolecular layer

... an uniform thickness of the intermediate layer in the samples was not achieved as well as the effect of this thickness on the fracture toughness was not ...

43

PELLETIZATION: A MOST SIGNIFICANT TECHNOLOGY IN THE PHARMACEUTICALS

PELLETIZATION: A MOST SIGNIFICANT TECHNOLOGY IN THE PHARMACEUTICALS

... In the last two decades, pellets have established their position for many reasons. Pellets offer a great flexibility in pharmaceutical solid dosage form design and development. They flow freely and pack easily without ...

32

Numerical Simulation of Forming Titanium Thin-wall Panels with Stiffeners

Numerical Simulation of Forming Titanium Thin-wall Panels with Stiffeners

... 0.016 inch (i.e. ~ 0.4 mm) are one of the materials that can be used for covers, including firewalls, without special testing for creep-resistance and heat-resistance Since shielding components do not require high ...

9

Stress Assessment Based on Ovality and Thickness Asymmetry for an Internally Pressurized Pipe Elbow at High Temperature

Stress Assessment Based on Ovality and Thickness Asymmetry for an Internally Pressurized Pipe Elbow at High Temperature

... At high temperature an internally pressurized pipe with large diameter used in supercritical and ultrasupercritical unit has shown its viscoelastoplastic material characteristics. In these applications the pipe is ...

7

Free Vibration Analysis of Circular Annular Plate with Rectangular Stiffener Patches

Free Vibration Analysis of Circular Annular Plate with Rectangular Stiffener Patches

... Plate with different rectangular stiffener patches has many engineering application such as automobile, aerospace, ship construction, naval structure, civil structure etc. The plate with different stiffener patches can ...

6

COMPARATIVE EVALUATION OF FILM FORMING PROPERTIES OF SOME NATURAL POLYMERS

COMPARATIVE EVALUATION OF FILM FORMING PROPERTIES OF SOME NATURAL POLYMERS

... The aim of the present work was to formulate and evaluate transdermal films using natural polymers and to check its effectiveness for control of drug release using Ibuprofen as model drug. Study was undertaken to report ...

10

Show all 9143 documents...

Related subjects