[PDF] Top 20 Utilization of Calcined Eggshell Waste as an Adsorbent for the Removal of Phenol from Aqueous Solution

... as adsorbent at a low cost for the removal of phenol from the waste ...extracts from waste were washed and then dried at a temperature of 60˚C and finally calcined ... See full document

... is adsorbent dose. As shown in Figure 2, the per- centages of phenol removal with increases in the amount of adsorbent experienced an upward ...the adsorbent that are unsaturated. Data ... See full document

... the removal of Pb (II) from radiator industry wastewater was studied by adjusting the pH to ...the adsorbent of particle size 125-250 µm and agitating with 50 mL of wastewater ...of adsorbent ... See full document

... for removal of phenol from synthetic effluent in a fixed ...initial phenol concentration, bed height and flow rate have significant effect on the kinetics of phenol ...(III) from ... See full document

... of phenol, since it determines the surface charge of fly ash and the degree of ionization and speciation of the adsorbate in solution ...% removal of phenol on FA-1 and FA-2 at pH values ... See full document

... treated phenol solution. When the initial phenol concentration is 400 mg/L, the adsorbed amount at equilibrium is maximised and rea- ches ...the phenol thus becomes more heavily favoured as ... See full document

... carbon from coconut coir for removal of phenol from the ...of adsorbent was studied through SEM and BET ...the adsorbent had a honey-combed microstructure with high surface ... See full document

... metals from large amount of industrial waste water ...on removal of phenol in aqueous solution have been ...materials[5-7]. Removal of Copper (II) from ... See full document

... Agricultural waste materials have little or no economic value and often pose a disposal ...The utilization of agricultural waste is of great significance for treatment of ...agricultural waste ... See full document

... of phenol concentration was studied by vary- ing the mass at the initial phenol concentration of ...increased from 0.5 to 3 g, the percentage of phenol removed on the adsorbent (gypsum) ... See full document

... mg/l, adsorbent dosage ...on removal of phenol by ...time, adsorbent was completely separated from the aqueous solution containing phenol using ...remaining ... See full document

... an adsorbent in the removal of Cu(II) ...[58]. From all these literature review, it is expected that sesame husk (SH) could be used as a promising adsorbent for removal of copper(II) ... See full document

... a solution plays an important role in adsorption processes as it can influence the chemical structure of metal ions and active sites of adsorbents ...The removal efficiency increased sharply with increasing ... See full document

... initial solution pH on the % dye adsorption by ...MB solution concentration were removed within 15 min of adsorption ...MB solution, very fast diffusion of MB molecules might have occured from ... See full document

... of adsorbent and contact time on adsorption of copper on powdered raw Pongamia pinnata tree bark was studied by batch ...ranging from 2 to 8, the initial concentration of metal ion from 10 to100 mgL ... See full document

... temperature, adsorbent dosage, and initial concentration of pollutant), their simultaneous interactions, and quadratic effects on crystal violet adsorption onto two starch based materials in the form of batch ... See full document

... their structure and molecular size [1, 2]. Some dyes have been found to act as substrate for metal ions and may import contamination by heavy metals [20]. There are various conventional methods of removing dyes including ... See full document

... clay from Al-Madinah Al-Munawwarah was modified by a solution of cetyltrimethylammonium bromide (C16TMABr) at different initial ...The removal properties of organoclays were dependent on the content ... See full document

... of adsorbent is increased gradually from 5 gm/L to 25 gm/L for a constant contact ...increases from 0.8 mg/gm to 1.5 mg/gm with increase in the adsorbent dose of 5 to 10 gm/L and then become ... See full document

... In order to accomplish the kinetics study the effect of contact time experiments on Chromate, Arsenate, vanadate sorption by surfactant modified mordenite, was carried out with 50mg/ ml concentration., ranging ... See full document