Al-Fe
Investigations on the Solidification Behavior of Al Fe Si Alloy in an Alternating Magnetic Field
... Binary Al-Fe phases predominate in low Si alloys or high Fe alloys, including equilibrium Al 3 Fe and metastable Al 6 ...
7
Tetragonal magnetostriction and magnetoelastic coupling in Fe Al, Fe Ga, Fe Ge, Fe Si, Fe Ga Al, and Fe Ga Ge alloys
... for Fe-Al, Fe-Ga, Fe-Ge, and Fe-Si, collectively referred to as “the binary alloys” in the rest of the ...the Fe-Ga-Ge and Fe-Ga-Al ternary systems, which give ...
15
Corrosion Study of Al-Fe (20 wt%) Alloy in Seawater Alkaline Solutions
... The observed morphology consists of elongated intermetallic grains and porosities dispersed in the bulk material [16]. EDS chemical maps illustrating the elements distribution is shown in Fig. 1b. It showed the Al ...
11
Application of the Wilson Equation for Zn Al Fe Alloy in Vacuum Distillation
... According to the characteristics and properties of hot gal- vanizing slag combined with industrial tests, this research adopts the experimental design software Design-Expert 8.0.6 experimental design (BBD) to study the ...
7
Calculated-Experimental Model for Multilayer Shield
... of Al-Pb, Al-Fe, and Fe-Pb, according to (7) for ...for Fe-Pb and Pb-Fe shields where the % error increases to about 8 % at ...
5
Precipitation in an Al 300 ppm Fe Alloy
... Iron and silicon are the typical impurities in aluminum alloys, and concentrations of (iron + silicon) and iron in commercial pure aluminum are prescribed as less than 1.0 mass% and 0.15–0.4 mass% in Japanese Industrial ...
8
Electrochemicalcoagulation Treatment in Simultaneous Arsenite and Fluoride Removal from Drinking Water
... that the main interference observed during simultaneous removal of arsenic and fluoride using freshly-prepared aluminum hydroxide is the formation of soluble complexes of Al-Fe, which solubilize aluminum ...
9
Modeling and Optimization of Electrocoagulation Process for the Removal of Yellow145 dye Based on Central Composite Design
... of Al and Fe were ...of Fe electrodes, while others pointed out to the advantages of using Al ...that Fe is relatively cheaper [31]. Fe forms more denser flocks of coagulated ...
12
Corrosion study of Fe-Al Intermetallic Alloys in Simulated Acid Rain
... the Al, Fe, and S. In acidic electrolytes, the presence of Al in the film is present in small quantities due to the better [29] aluminum oxide ...alloy Fe 3 Al sting, can be ...
14
Corrosion Performance of Fe-Al Intermetallic Coatings in 1.0 M NaOH Solution
... both Fe and Al have protective properties and that the electrochemical behavior of pure Fe and Fe28Al have the same performance ...of Fe and Al (Fe(OH) 2 , Al(OH) 3 ) ...
14
Decolourization of Textile Dyebath Chloride Rich Wastewater by Electrolytic Processes
... length, 4.7 cm width and 33.3 cm height. Two electrodes each of 4.9 cm width, 20 cm length and 3mm thickness with an effective electrode area of 0.0098m 2 , were used as anode and cathode inside the reactor. Four ...
13
Fabrication of Fe Al nanoparticles by selective oxidation of Fe Al thin films
... the Fe-Al films were selectively oxidized, the slope of the hysteresis loops at the origin decreased, due to the demagnetization field, as the oxidation time in- ...the Fe-Al films of Figure 7 ...
6
Theoretical Predict of Half Metals in Co Cr Fe Al Alloys
... with Fe atom in pure iron, because the potential around Co is deeper than that of ...and Fe of the up-spin state have some peaks in the same energy range, that is, the d-states of Co and Fe hybridize ...
5
Undigested Distillery Spentwash Treatment by Electrocoagulation process Using Al-Al and Fe-Fe Electrodes
... Abstract— Electrocoagulation (EC) of undigested distillery spentwash with high color removal efficiency and COD was investigated using a set of aluminium and iron electrodes. The distillery spentwash was characterized ...
5
Effect of Mn or Fe Addition on Age Hardening Behaviour of Al Mg2Si Alloys
... or Fe content in the alloys; (2) the addition of ...or Fe content; and (3) the predominant precipitates is observed as the random- type precipitates for the base alloy but the parallelogram-type ...
8
1 Co-, Cu- and Fe-Doped Ni/Al 2O3 Catalysts for the
... Ni/Al 96.70 0.13 0.03 0.00 0.30 2.84 90 16 26.14 0.3407 5.6 Ni-Co/Al 95.84 0.14 0.00 0.00 1.04 2.98 96 19 26.19 0.3400 5.5 Ni-Cu/Al 97.80 0.22 0.07 0.00 0.39 1.52 130 39 26.29 0.3387 6.5 ...
15
Nano mechanical properties of Fe Mn Al C lightweight steels
... were studied. The Ni-containing samples were found to have a higher hardness due to the B2 phase composition being NiAl rather than FeAl, with Ni-Al bonds reported to be stronger than the Fe-Al ...
13
Morphology of Compounds Formed by Isothermal Reactive Diffusion between Solid Fe and Liquid Al
... On the other hand, the interdiffusion for the perpendicular growth is affected by the mass transport for the parallel growth. As a result, the parallel growth as well as the perpendicular growth influences the growth ...
9
Softening by Coarsening of Ni Al B2 Phase Particles in Fe Cr Ni Al Zr Alloy
... possibility that an increased hardness due to precipitation strengthening can be obtained in Fe-Cr-Ni-Al stainless steel. Figure 1(a), as described before, shows a heat and working pattern before being ...
5
STM study of the atomic structure of the icosahedral Al Cu Fe fivefold surface
... Finally, we point out that the atomic-resolution STM im- ages of i-Al-Cu-Fe presented in this paper are quite different than those for the i-Al-Pd-Mn 5 f surface. On the latter sur- face, pentagonal ...
6