[PDF] Top 20 Static Analysis and Optimization of Outriggers in A Tall Building

... Fig-7 & Fig-8 indicates that deflection decreases by increasing outrigger rigidity. It is observed that the maximum reduction of 29% and 25% is obtained when outrigger is placed at mid-height of the building ... See full document

... in tall buildings and has been widely studied over the past decades ...concrete tall building structures with outriggers ...outrigger-braced tall building structure is subjected ... See full document

... a tall build- ing should be considered in the design phase, and proper measures should be taken to reduce their unfavora- ble ...study, outriggers, which have been designed to reduce the lateral ... See full document

... the building. In both the types outriggers and belt truss are provided at different location to obtain reducing lateral ...the analysis ETABS software has been used. The type of building ... See full document

... a static non linear analysis under permanent vertical loads and gradually increasing lateral ...Pushover analysis is that, as Indian buildings built over decades are seismically deficient due to lack ... See full document

... the building increases and become narrower therefore the stiffness of the building ...For building taller than certain height, moment resisting frame structure, shear wall structure, braced frame ... See full document

... High-rise building is trending nowadays as there is a rapid growth of the urban ...structure, outriggers, ...the building, the length and thickness may ... See full document

... The current research is to compare the performance of 3D strengthened structure under both static and dynamic strategies. Modeling and research are done in ETABS. The structure is analysed under static and ... See full document

... design, building with new innovative ideas most of the time it is with the sky touching ...“dia-grid”. Analysis has been carried out using different method of analysis for static earthquake ... See full document

... of outriggers at different levels under the action of elastic, creep and shrinkage ...present analysis is carried out using a finite element software MIDASGen and by plotting storey height versus ... See full document

... In third case, all the data and loading are same as in second case. The outrigger beam ISLB 200 is provided at half height of frame (i.e. at 15.5 m from base respectively). The above three cases are modelled and ... See full document

... the building during the entire period of the fire was ...the static step and fire temperature ...the static load (Dead and Live) to catch the crack behavior of the concrete slab under gravity load ... See full document

... Earthquake and wind storm are a universal problem for all building, but more critical for tall buildings as they are more sensitive to lateral movement. Exactly, reducing displacement is the priority ... See full document

... the static analysis has been done in steering arm with the load of 40 and 45 ...the analysis result has been concluded that, the values obtained for the SG iron in maximum stresses ...Topology ... See full document

... hard to avoid even happens repeatedly, it causes swelling of the cost and time of implementation. In a previous study concluded that the cost of repairs due to defects employment of 4% of the value of construction ... See full document

... of building. The factors that influence the functioning of tall buildings are mainly serviceability, strength and ...the tall buildings have to resist are the wind and seismic ...the building ... See full document

... Design of the building is done to compare the % steel reinforcement, maximum shear force, maximum bending moment and displacement for all four seismic zones. Different values of zone factor are used for the ... See full document

... and Optimization of crankshaft and compared the fatigue performance of two competing materials of crankshaft namely forged steel and ductile cast ...The optimization process included geometry changes ... See full document

... Heating and cooling loads are thermal energy that must be supplied or removed from the interior of a building in order to maintain comfortable conditions. Once the loads have been established, one can proceed to ... See full document

... The different loads assigned are dead load (IS 875 part 1-1987), live load (IS 875 part 2- 1987) and seismic loads (IS 1893-2002). Gravity loads on structures include the weight of beams, slabs, column and walls. The ... See full document