fault types
Automatic Identification of Sewer Fault Types Using CCTV Footage
... identify types of detected faults aiming to further improve the efficiency and accuracy ...the fault type in 71% of frames. Most common fault types were included in this experiment, covering a ...
8
Identification of Fault Types for Underground Cable using Discrete Wavelet Transform
... with fault appearance along the underground cable distribution system have been investigated in this ...in fault detection decision ...the fault detection decision algorithm can detect fault ...
5
Review of Fault Types, Impacts, and Management Solutions in Smart Grid Systems
... two types: the load propagation failure that occur due to an overloaded in the SGS, and the interdependent failure that oc- curs due to the nature of the relation between the two networks ...
20
Emergent Failures:Rethinking Cloud Reliability at Scale
... all types of faults and failures that may potentially ...microprocessor types (CPU, GPU, NPU, ...different fault types and component interactions that the system is not originally designed ...
8
A New Scheme Based on Correlation Technique for Generator Stator Fault Detection-Part π
... internal fault conditions at various fault types and resistances are obtained, trip signal is initiated with fault start due to cross-correlation coefficient between the two current signals of ...
7
A New Principle of Fault Identification of on the Same Tower Based on Traveling Wave Reactive Powers
... a fault occurs out of the protection zone, the ratio of the traveling wave reactive power on the same side of the double-circuit line of the same tower is approximately the same when a fault occurs out of ...
21
ANN based directional relaying scheme for protection of Korba-Bhilai transmission line of Chhattisgarh state
... of fault is accomplished within half cycle of ...the fault and secondly to identify the zone of fault and the direction (whether it is forward or reverse ...different fault parameter like ...
17
Fault Detection and Isolation of Vehicle Driveline System
... resulting fault detection system is able to properly locate the fault types under all test conditions, and is sensitive also to fault ...
11
Analysis of Fault location methods on transmission lines
... components. Fault voltages and currents from both terminals were transformed into positive and negative ...all fault types [8]. However, it is not suitable for balanced fault like three phase ...
88
Stability Improvement of FSIG based Grid Connected Wind Farm Using STATCOM/SVC during different Fault Locations
... and fault state condition. At the fault state, the voltage, active power and reactive power are monitored at the main bus ...during fault events and after fault ...During fault period, ...
9
Impact of IPFC on Distance Protection of Multiline Transmission System
... different fault types, fault locations, and fault resistances is analyzed to show the impact of VSC-based IPFC on distance protection of the multiline ...the fault to the right of IPFC ...
7
Three Zone Protection By Using Distance Relays in SIMULINK/MATLAB
... the fault line is decreased below a pre- specified value the relay circuit senses the fault and gives a signal to the circuit breaker to open the ...
10
Fuzzy Logic Method in SCADA to Optimize Network Electric Power Smart Grid
... For measurement, the data was obtained from the following ways: First, by using the data changes to large voltages and currents generated by the devices on site plant so that voltage and current received central computer ...
5
PROPOSAL OF CONTENT MAINTENANCE OF CNC MACHINE USING METHODS RELIABILITY CENTERED MAINTENANCE
... Why it is not always correct and effective use methods posterior confidence? A surprising number of people believe that effective mainte- nance policy can be formulated only on the basis of historical information about ...
8
Solar PV Module Fault Analysis Using Artificial Intelligence
... and fault analysis in electrical solar PV(photo voltaic) systems is ...All fault cases like module to module fault, short circuit fault, open circuit fault, cell- ground faults and ...
8
Vol 2, No 2 (2016)
... A fault analysis tool should be able to detect the fault event by automatically interpreting recorded transients captured during relay trip operation and then estimate the fault location in the ...
6
In-Field Test for Permanent Faults in FIFO Buffers of NoC Routers
... The transparent SOA-MATS++ algorithm is intended for test of stuck-at fault, transient fault, and read stuck-at fault, transition fault, and read disturb fault t[r] ...
5
AC/DC converter with DC fault suppression for aircraft +/- 270 VDC distribution systems
... DC fault is to isolate interconnected AC-sides through front-end AC breakers ...acting fault suppression method with reliable performance and ability to restore electrical power as quickly as ...DC ...
12
Digital Signal Design for Fault Detection in Linear Continuous Dynamical Systems
... observation. It is also the minimal piecewise constant one with n + 1 uniform steps. Therefore it guarantees fault detection in the original continuous time problem for the given error bounds. The SDS test signal ...
157
Impact of converter interface type on the protection requirements for DC aircraft power systems
... One means of limiting current output when antiparallel diodes exist within the converter is to utilize a crowbar. A crowbar can be applied by either activating a physical crowbar on the source side [15] or by turning on ...
13