Horizontal Pipe
EXPERIMENTAL STUDIES OF HIGH VISCOSITY OIL-WATER (WATER-ASSIST) FLOW BEHAVIOR IN HORIZONTAL PIPE
... The comparison of the flow pattern maps of the present research with Sotgia et al. (2008) are as presented on Figure 10 to 11. Two maps were generated by Sotgia et al. (2008) based on the pipe materials; plexiglas ...
14
Modelling air and water two phase annular flow in small horizontal pipe
... Numerical simulation using computational fluid dynamics (CFD) has been carried out to study air and water two-phase flow in a small horizontal pipe of an inner diameter of 8.8mm, in order to investigate ...
12
MHD FLOW IN A CIRCULAR HORIZONTAL PIPE UNDER HEAT SOURCE/SINK WITH SUCTION/INJECTION ON WALL
... In the present article, we inspect hypothetically the 2D heat transport responses in a horizontal pipe under related magnetic field, constant suc- tion and heat source/sink forced at surface of the tube. ...
8
CFD simulation of bubbly Diesel CNG flow in a horizontal pipe under the influence of a magnetic field
... The literature review showed that various researches have studied the effects of uniform or non- uniform magnetic field on vertical two-phase flows. But effects of change intensity of uniform magnetic field on bubbly ...
6
Simulation and Experimental of Oil-Water Flow with Effect of Heat Transfer in Horizontal Pipe
... in pipe in the experimental ...main pipe flow test section made from 32mm inner diameter and 6m ...copper pipe of 32mm diameter with a circular cross section ...test pipe section is ...
11
Experimental investigation on the vibration induced by slug flow in horizontal pipe
... Industrial pipe systems are generally used in many arenas like hydropower power plants, transportation of the gas and oil, urban water supply and nuclear ...industry. Pipe systems facing the dynamic forces ...
6
An experimental investigation into non-isothermal flow of air in a horizontal pipe.
... Ambient air was forced by a centrifugal fan into the settling chamber from which it was lead to the flowmeter through a gate valve. This measured air was then piped to the furnace to be heated to any desired temperature. ...
207
Experimental study of the hydrodynamic behaviour of slug flow in a horizontal pipe
... were measured using two pairs of Electrical Capacitance Tomography (ECT) probes. The expected linear dependence of the translational Taylor bubble velocity on the mixture superficial velocity was confirmed. Pressure drop ...
50
Evaluation of Wave Characteristics in Annular Flow in Horizontal Pipes
... in horizontal flow in pipes were conducted with emphasis on wave characteristics (wave velocity, wave frequency) and liquid film ...0.0504m pipe diameter with a total flow loop length of ...in ...
9
Experiment and Simulation of Ferrous Ions Diffusion at the Dead-end Branch Pipes of Water Distribution System
... In this paper, the computational fluid dynamics software COMSOL was used to simulate the diffusion of the dead-end branch pipes. We used 2D models to build the geometry of the dead-end branch pipe and the main ...
8
Measurement of particle concentration in horizontal, multiphase pipe flow using acoustic methods: Limiting concentration and the effect of attenuation
... in horizontal pipe flow were computed for validation purposes using an existing explicit, dual-frequency concentration inversion method (Hurther et ...
37
Pressure Surge Dependence on Valve Operations in a Pipeline Loading System
... and Pipe parameters that could not be measured directly or derived from data or log ...the pipe on shut down at any ...the pipe capable of reducing the crude oil pressure below its vapour ...
9
Extending the persistent primary variable algorithm to simulate non-isothermal two-phase two-component flow with phase change phenomena
... 5, the heat pipe was represented by a 2D horizontal column (2.25 m in length and 0.2 m in diameter) of porous media, which was partially saturated with a liquid phase saturation value of[r] ...
23
Fatigue studies on stainless steel piping materials and components: Indian AHWR
... Fatigue is one of the mechanisms, considered active in the piping system, which may lead to crack initiation from either the highly stressed regions or the undetected flaws. It is desirable to confirm that crack ...
8
Online Full Text
... a pipe of width 2W under gravity, hitting a horizontal wall of infinite length placed at a vertical distance H from the bottom edges of the pipe and splitting symmetrically into two jets one on each ...
6
Heat Pipe for Aerospace Applications—An Overview
... heat pipe laser mirror was designed and fa- bricated in order to test the feasibility of this technology compared to water-cool or un-cooled mirrors for high power lasers ...heat pipe mirror was ...
14
Experimental and Comparison Study of Heat Transfer Characteristics of Wickless Heat Pipes by using Various Heat Inputs
... The heat pipe generally consists of three sections namely, evaporating section, adiabatic section and condensation section. There are four RTDs in each pipes. One in the evaporating section, one in the ...
12
Design and Analysis of Buried Pipe for Pressure Loads
... a pipe occurs when the applied stresses in the pipe exceeds the structural capacity of the ...the pipe material. The failures in the pipe barrel and joint result from a combination of causes ...
10
OPTIMIZATION OF PIPE SPECIFICATION FOR WELDING IN B WAVE STRUCTURE USING TAGUCHI PARAMETRIC OPTIMIZATION TECHNIQUE.
... In this step, the controllable factors are material (M), thickness of pipe (T) and diameter of pipe (D) which was selected because these are the factors which affect the induced compressive stress. Since ...
7
Comparison of Effectiveness of Two Different Setups of Double Pipe Heat Exchangers
... P.SIVASANMUGAN AND S.SUNDARAM -The velocity field for the mechanism of flow associated with a tube tested with twisted tape was analysed by Lopina and Bergles. Also they reported a model for the prediction of the heat ...
13