power system load bus
Effect of NTL on Power System Losses at Industrial Load
... appropriate load flow studies using Matlab ...that power flow solutions are used to estimate the states at various points in the ...electrical power systems can be ...NTL load power ...
6
Load Flow And Contingency Studies For The Nigeria 31-Bus 330-Kv Power System
... compensation). However, after the installation of compensations, the real and reactive powers generated reduced to 4221.88MW and 204.4259MVAR respectively. The implication of this is that 19.125MW of electricity has been ...
9
Comparative Analysis of Load Flow Methods on Standard Bus System
... less power penalty and less iteration than the other ...accuracy load flow obtained in a few systems only, the Newton-Raphson method is better to the use and more reliable than any other ...
6
The Distribution Network Reconfiguration By Using Multipopulation Evolutionary Programming (MPEP) For Loss Minimizing
... to system constraints consisting of load-point voltage limits, radial configuration format in feeder reconfiguration problem to the distribution system with distributed generation can be solved by ...
24
Analysis and Optimal Utilization of Series Inverter UPQC for Simultaneous Voltage Sag/Swell and Load Reactive Power Compensation
... different power quality problem makes extremely vulnerable the modern power distribution ...a power system is further imposing new challenges on the electrical power industry to ...
12
Analysis of Voltage Collapse in a Power System Using Voltage Stability Indices
... This bus (10) also has the minimum permissible reactive power load of 368MVar compared with all other load buses of the Southern Indian 10-bus power ...reactive power ...
6
An Efficient Method for Economic Supply of Incremental Power under Deregulation
... generator bus at a ...the Load node, only one generator responds at a ...by Power Grid Corporation of ...generator bus only at a time to serve incremental load at a load ...
8
MOPSO approach for FACTS device installation in power system
... when bus 26 is subjected 20MVar using MOPSO and MOEP are illustrated in ...at load bus system the voltage profile has been increased greater than ...IEEE-30 Bus RTS with optimal ...
6
Demand Response Algorithms to Improve Electric Power System Stability Margins
... driven power systems to operate closer to their stability boundaries, increasing the risk of ...optimal power flow approach that uses demand responsive loads to improve steady-state voltage stability, which ...
10
Voltage Profile Analysis in Power Transmission System based on STATCOM using Artificial Neural Network in MATLAB/SIMULINK
... reactive power conditions in AC ...of power oscillation damping. In This paper the reactive power compensation capability of STATCOM for wind power integration into a weak distribution network ...
9
Load Flow Solution of the Tanzanian Power Network Using Newton-Raphson Method and MATLAB Software
... control system or using approximate models. In system studies where system alternatives must be explored in detail, or when developing protection schemes and operating criteria to maintain the ...
10
Development of early warning methods for voltage instability in electric power system
... The apparent power at each bus and the RE1 network Graph of load voltage with Thevenin voltage and load impedance with Thevenin impedance by KF The point of collapse traced by using KF a[r] ...
37
Power System Stabilizer for Single Machine Infinite Bus System
... multi-machine system. Secondly The Fuzzy logic based PSS system was tuned as per rotor angle and speed deviation characteristics of the PSS controller under the varying operating conditions of the ...
8
Utilize Distributed Power-Flow ControllerTo Compensate Unbalanced Voltage In Nine Bus System
... the system in order to regulate the load side ...distribution system between the supply and the critical load ...any power disruption to that load DVR is used to boost up the ...
8
Load Flow analysis & simulation on IEEE 30 bus system
... a Load flow analysis on IEEE-30 bus system was conducted and the effects of load ...reactive power modelling greatly affected the voltage difference, whereas the active power ...
10
Solving DOPF in VSWGs Integrated Power System Using Improved Evolutionary Programming
... 30-bus system (see Fig.2) and IEEE 39- bus system (see ...rating power of which reaches 36MW, are connected to the system at the bus 6 for the modified IEEE 30-bus ...
8
An IPM CFAPSO based Hybrid Method for Multiple Objective Minimizations using TCPS
... secure system can be assured by enhancing the voltage stability profile throughout the whole power ...each bus of the system. The indicator value varies between 0 (no load case) and 1 ...
8
Optimal Placement and Sizing of SVC in Power System for Voltage Stability Improvement using Harmony Search Algorithm
... the power flow ...the system stability ...complete system. Voltage stability index Lj for any load bus can be defined as given in equation (13) ...
7
Solving Load Flow Problems of Power System by Explicit Pseudo Transient Continuation (E ψtc) Method
... For the 43-bus system, if the voltage initial values of all buses are (0.7, j*0). The normal Newton method (double precision) continues to oscillate. The optimal multipliers of the optimal multiplier method ...
17
Implementation of wampac security and stability improvement of power grids with systems
... to bus 4, the load is directly supplied by the second generator and is responsible for supplying a large amount of ...that power dividing and sharing depends on the location of the load pulse ...
11