solid wall
Assessing the quality of retrofits in solid wall dwellings
... Furthermore, retrofit performance gaps have been observed to result in energy penalties, moisture problems and other unintended consequences, especially for solid wall retrofits (TSB, 2014, Innovate UK, ...
42
The staged retrofit of a solid wall property under controlled conditions
... The solid wall insulation made a major contribution to the overall performance ...the wall system’s ...internal wall insulation performed closely to the design ...
26
Simulation of conjugate heat transfer between fluid saturated porous media and solid wall
... the solid wall acts as an adiabatic layer so the difference between the temperature on the interface and that on the cold wall is very small, as shown by ...conjugate wall becomes very much ...
28
Modelling insulated coving's potential to reducing thermal bridging and moisture risk in solid wall dwellings retrofitted with external wall insulation
... External wall insulation (EWI) is major component of English Government domestic energy efficiency policy, included within the Energy Company Obligation ...many solid wall properties, especially as a ...
19
Measurement of Bubble Behavior and Impact on Solid Wall Induced by Fiber Holmium:YAG Laser
... nearby solid wall following fiber laser-induced bubble ...without solid boundaries (distance between the wall and fiber tip) to reveal the optimum laser irradiation conditions for the ...
9
Understanding and controlling the ingress of driven rain through exposed, solid wall masonry structures
... these solid wall structures, this paper focuses on the laboratory work done to inform the writing of a Technical Advice Note on the effects of wind driven rain and moisture movement in historic structures ...
47
The staged retrofit of a solid wall property under controlled conditions
... permeability of the property. This does mean that while rapid evaluation and comparison of thermal upgrades is greatly enhanced by the facility, longer term hygrothermal issues such as interstitial condensation can only ...
28
Validating Solid Wall Insulation Retrofits with In Use Data
... Improving the energy efficiency of the UK housing stock is important both to meet carbon emission reduction targets and to reduce fuel poverty. For this reason, domestic properties are frequently retrofitted with energy ...
9
Abstract The flow of a viscous fluid over a thin deformable porous layer fixed to the solid wall of a
... where a is the apparent viscosity of the fluid in the porous material, is the Lame constant, f is the coefficient of viscosity, q is the flow velocity, u is the displacement, K is the drag coefficient, G 0 is the ...
9
Short wavelength instability in the vortex ring during impingement onto a solid wall
... Experiments on impinging vortex ring are not few. Earlier flow visualization [1] using colored dye revealed that the original ring expands in diameter when the wall is approached. In the meantime, a boundary layer ...
7
Measuring and modelling retrofit fabric performance in solid wall conjoined dwellings
... Although the values are described as ‘measured’ in Table 3, the air changes per hour are derived from the air tightness test results. The SAP air changes per hour value for the post-retrofit model of Dwelling A increases ...
53
The Influence of the Proximity of a Solid Wall on the Consistency of Viscous and Plastic Materials
... the former is fixed when the latter is fixed), the volume extruded in unit time will depend, for a given stress at the wall of the tube, upon the cube of the radius. While this is true for fluids, and is also true ...
16
Mapping the Wall Region Dynamics of High Flux Gas Solid Riser Using Scaling Regions from the Solid Concentration Time Series
... the wall region, starting from r / R = ...the wall ( r / R = ...the wall for all flow development sections especially at higher embedding ...from solid-solid interactions, ...
19
Experimental study on tsunami risk reduction on coastal building fronted by sea wall
... using solid box made up of plywood (length, width, height: 8 cm × 8 cm × 8 cm) with a scale of ...sea wall in reducing forces on building ...and wall 2, H2 = 8 cm high). The length and width for sea ...
8
Development of Interaction Diagram for Eccentrically Loaded RC Sandwich Walls with Different Design Parameters
... sandwich wall to those of the solid wall (Po and Mo) at the same eccentricity ratio (e/t) is calculated using the data obtained from solid and sandwich walls ...sandwich wall while the ...
6
Optimization of facade design based on the impact of interior obstructions to daylighting
... wide solid walls is at least 600 mm higher than the required working plane so that the daylight level on the working plane can reach 800 lux , and 500 lux daylight can penetrate 350 mm or more deeper into the ...
22
Lattice Boltzmann phase-field modeling of thermocapillary flows in a confined microchannel
... a solid wall and subject to a simple shear flow when a laser is applied to locally heat the fluids, and investigate the influence of contact angle and fluid viscosity ratio on the droplet dynamical ...
23
Numerical computation of turbulent conjugate heat transfer in air heater
... housing solid wall is influenced by the flow con- ditions near the solid bounary, accurate prediction of turbulent viscosity and recirculation regions is of main importance in assuring an accurate ...
6
Simulation on Cavitation Bubble Collapsing with Lattice Boltzmann Method
... near solid walls, the computational domain consists of 401 × 401 grid nodes for bubble collapse simulation as shown in Figure 2, the adhesion between fluid and solid wall is setting as ...
9
CFRP Grid/Rigid Foam Shear Transfer Mechanism for Precast, Prestressed Concrete Sandwich Wall Panels.
... sandwich wall panels have been effectively used for decades to provide the building envelope for a wide variety of ...or solid concrete zones have been used to accomplish this transfer of shear ...
210