• No results found

zero-voltage-switching buck converter

Zero-voltage-switching buck converter with low-voltage stress using coupled inductor

Zero-voltage-switching buck converter with low-voltage stress using coupled inductor

... as voltage regulator module (VRM), power factor correction (PFC), renewable energy system, power supply and so ...increase switching frequency, which allows for considerable size reduction of the passive ...

20

Design zero voltage switching DC DC buck converter

Design zero voltage switching DC DC buck converter

... hard- switching PWM regulators, is that as frequency increases, then so do switching ...higher switching frequency leads directly to higher ...

36

An Adaptive Fuzzy PID Control of Zero Current Switching Resonant Buck Converter

An Adaptive Fuzzy PID Control of Zero Current Switching Resonant Buck Converter

... maximum switching frequency and current ...in switching losses and improves the switching ...off switching loss. ZCS eliminates the voltage and current overlap by forcing the switch ...

8

Design of zero current switching DC DC buck converter

Design of zero current switching DC DC buck converter

... If anti-parallel diode is connected across the switch, the converter will be operating in full-wave mode. The circuit schematic is shown in Figure 2.18. The circuit waveforms in steady state are shown in Figure ...

38

Double Input Zero Voltage Switching Boost Converter For Low Power Applications

Double Input Zero Voltage Switching Boost Converter For Low Power Applications

... input voltage. There are various dc-dc converter topologies such as buck, boost, buck-boost, Cuk and full bridge ...the buck and boost are the basic converter ...basic ...

5

Inherent Clamp Flyback-Buck Converter with Winding Cross-Coupled Inductors Zero Current Switching

Inherent Clamp Flyback-Buck Converter with Winding Cross-Coupled Inductors Zero Current Switching

... The movement of electrons from upper layer to the lower layer through the wire is electrical current. The output voltage of the panel depends on the number of cells connected in series. The output wattage is ...

11

Improved Power Quality Single Mode Power Supply using Buck-Boost Converter

Improved Power Quality Single Mode Power Supply using Buck-Boost Converter

... at zero current or zero voltage. In zero current switching, the switch turns ON from a finite blocking voltage to zero ON state current and turns OFF at zero ON ...

6

Five-Level Full-Bridge Zero Voltage and Zero Current Switching DC-DC Converter Topology

Five-Level Full-Bridge Zero Voltage and Zero Current Switching DC-DC Converter Topology

... dc voltage conversion and shows that the system operates as a transformer zed buck ...the switching scheme achieves soft ...The switching scheme can be simplified by controlling the devices in ...

12

Comparison of Buck Converter and Resonant Buck Converter

Comparison of Buck Converter and Resonant Buck Converter

... at zero voltage, it helps to reduce the switching losses, stress while switching, dv/dt and thus Electro Magnetic ...resonant buck converter is suitable for high-frequency ...

5

A Single Phase High Power Factor AC-DC converter with Soft Switching Characteristics

A Single Phase High Power Factor AC-DC converter with Soft Switching Characteristics

... ac-dc converter with soft switching ...a buck converter and a boost converter that integrates to form the proposed circuit ...boost converter operates in discontinuous-conduction ...

7

ZVS Boost Converter with A Flyback Snubber Circuit

ZVS Boost Converter with A Flyback Snubber Circuit

... proposed converter configuration can achieve both near zero-voltage and zero-current soft-switching features, while it can reduce the current and voltage stresses of the main ...

8

Vol 2, No 8 (2014)

Vol 2, No 8 (2014)

... high voltage (HV) with Low current and low conduction ...dc–dc converter for a variety of applications such as battery-based uninterrupted power sup- plies to mission critical aerospace applications, ...

10

Switching at Zero Voltage Level

Switching at Zero Voltage Level

... the zero crossing of the voltage is detected. As the zero crossing level of the voltage is detected, the comparator generates the pulse which is given to the Arduino Nano ...

5

Modelling of Buck DC-DC Converter Using Simulink

Modelling of Buck DC-DC Converter Using Simulink

... this voltage, the diode becomes forward-biased and causes the current flow to continue and decay ...a voltage source, but solely due to the stored energy in the ...

11

Development of time delay voltage control for lead acid battery using Arduino

Development of time delay voltage control for lead acid battery using Arduino

... general, converter has several topologies such as boost, buck, buck–boost and multi-level ...the converter depends on the different applications that have been ...are buck, boost, ...

38

Online learning neural network control of buck boost converter

Online learning neural network control of buck boost converter

... DC-DC buck-boost converter using online learning ...output voltage of the DC-DC converter and to improve performance of the Buck-Boost converter during transient ...reference ...

5

A Novel Method for Modeling and Simulation of Asymmetrical Impedance-source Converters

A Novel Method for Modeling and Simulation of Asymmetrical Impedance-source Converters

... power converter have been proposed to solve the problems associated with impedance source ...output voltage level, low number of active and passive elements and low requirement to achieve the high turn's ...

11

Analysis of ZVS Isolated Converter using MATAB-SIMULINK

Analysis of ZVS Isolated Converter using MATAB-SIMULINK

... Soft switching is the technique to eliminate the losses due to hard switching conditions and to have high frequency operation without any reduction in the efficiency of the ...the voltage across or ...

8

Design of Novel Closed Loop Controlled Fully Soft-Switched Isolated DC–DC Converter

Design of Novel Closed Loop Controlled Fully Soft-Switched Isolated DC–DC Converter

... e switching frequency has to be ...high switching frequency causehi gh stress on the switch. If soft switching techniques have b een used these switching stress can be avoided ...onant ...

8

Vol 4, No 5 (2016)

Vol 4, No 5 (2016)

... proposed converter is worked under intermittent mode ...and buck–boost converter ...information voltage at each exchanging cycle when the obligation cycle quality is consistent; in this way, ...

8

Show all 10000 documents...

Related subjects