• No results found

power control system performance

A NOVEL APPROACH TO GENERATE DISTRIBUTED GLOBAL AND LOCAL USE CASES: A NEW 
NOTATION

A NOVEL APPROACH TO GENERATE DISTRIBUTED GLOBAL AND LOCAL USE CASES: A NEW NOTATION

... the system but not the interference at cell ...which control the system performance to ensure the highest data rate and spectral ...its performance along with different FR schemes and ...

14

Control Performance Standard based Load Frequency Control of a two area Reheat Interconnected Power System considering Governor Dead Band nonlinearity using Fuzzy Neural Network

Control Performance Standard based Load Frequency Control of a two area Reheat Interconnected Power System considering Governor Dead Band nonlinearity using Fuzzy Neural Network

... where φ(T) is the root-mean-square (RMS) of all the T minute average ACE values over the past 12 months. It is shown in [8] that if ACE were a random signal, φ (T) would be proportional to 1/T. Of course ACE itself ...

8

Mitigation of Harmonic Current Using Active Filter with Fuzzy Control in Distribution System

Mitigation of Harmonic Current Using Active Filter with Fuzzy Control in Distribution System

... the performance of distribution equipment in ways such as heating, vibration ...distribution power system [2], [3], [4], [5], ...electric power systems (IEEE ...

9

Evolutionary Computation Based Load Frequency Control of Non linear Practical Power System with Diverse Source of Power Generation

Evolutionary Computation Based Load Frequency Control of Non linear Practical Power System with Diverse Source of Power Generation

... The performance of EPSO, BFOA, DE and CEPSO algorithm is tested using MATLAB ...a performance comparison between different applied algorithms is carried out to validate the superiority of one algorithm over ...

7

Performance of CDMA power control for HAPS

Performance of CDMA power control for HAPS

... In [10], the effect of HAPS instability/movement on the effect to the capacity of CDMA system using two schemes of distance-based power control was evaluated and quantified. ITU has specified that ...

42

Control of DFIG based wind generation systems under unbalanced network supply

Control of DFIG based wind generation systems under unbalanced network supply

... The performance of a DFIG system operating under unbalanced conditions using the proposed control strategy is evaluated by simulations using torque/power oscillations exist with the conv[r] ...

6

Nonlinear Analysis of Interaction with SVC in Stressed Power Systems: Effect of SVC Controller Parameters

Nonlinear Analysis of Interaction with SVC in Stressed Power Systems: Effect of SVC Controller Parameters

... steam power plant turbine-generator set is studied using the Modal Series (MS) and Normal Form (NF) ...a power system equipped with SVC is ...SVC control parameters will adversely affect the ...

10

Battery Energy Storage Station Based Smoothing Control Of Wind Power Generation Fluctuations

Battery Energy Storage Station Based Smoothing Control Of Wind Power Generation Fluctuations

... to control electrical torque and reactive power helps to provide better performance considering the system ...total power to achievefull control of the ...storing system ...

5

Index Terms: Multi-Level Inverter, Static Synchronous Compensator (STATCOM), Fault Detection and Provide Active and Reactive Power Compensation Technique.

Index Terms: Multi-Level Inverter, Static Synchronous Compensator (STATCOM), Fault Detection and Provide Active and Reactive Power Compensation Technique.

... advanced power electronic components are developed by the FACTS controlled ...the power system; 2) it operated under low voltages then corresponding the voltage stress in the STATCOM is also ...

7

Minimization of Real and Reactive Power Loss by Incorporation of STATCOM Using Newton Raphson Load Flow Method
                 

Minimization of Real and Reactive Power Loss by Incorporation of STATCOM Using Newton Raphson Load Flow Method  

... for power transmission ...state power system operation; in addition, they improve the dynamic and transient performance of the power ...and control power flow over ...

6

Performance improvement of a wind energy system using fuzzy logic based pitch angle control

Performance improvement of a wind energy system using fuzzy logic based pitch angle control

... two control modes (power and speed) in order to achieve above tasks ...in power control mode with switch set to input 1 when the wind speed exceeds its rated speed to maintain the output ...

8

To Analysis the performance of two area power system in Automatic Generation Control based on MATLAB

To Analysis the performance of two area power system in Automatic Generation Control based on MATLAB

... frequency control problem associated in single and Two-area electrical power ...uncontrolled system is studied and then improvement of its response is learnt on the application of integral ...area ...

9

Improvement in Power System Performance Based on Power Compensation

Improvement in Power System Performance Based on Power Compensation

... When the load will be connected to the system, the voltage and current at the Grid will be distorted and will need to be filtered. Here the STATCOM (Active filter) will be activated and will inject the exact ...

5

Developments of power system protection and control

Developments of power system protection and control

... advance power system protection, especially the ‘ Adaptive Protection’ and the Artificial Intelligence (AI)-based protection techniques proposed in the 1980s and ...the power system as much as ...

8

Study and Effects of UPFC and its Control System for Power Flow Control and Voltage Injection in a Power System

Study and Effects of UPFC and its Control System for Power Flow Control and Voltage Injection in a Power System

... to control the real and reactive line power flow inserting an opportune voltage with controllable magnitude and phase in series with the transmission ...stability control to suppress power ...

9

Analysis of the Impact of P Ratio on BER, Q Factor and OSNR of Radio over Fiber (RoF) System

Analysis of the Impact of P Ratio on BER, Q Factor and OSNR of Radio over Fiber (RoF) System

... carrier power to total received RF power at control office (CO) on Bit error rate (BER), Q- performance parameter and Optical signal noise ratio (OSNR) of RoF communication system is ...

10

Forward link power control for high altitude platform station w-cdma system

Forward link power control for high altitude platform station w-cdma system

... “Minimum Performance Characteristics and Operational Conditions for High Altitude Platform Stations Providing IMT-2000 in the bands 1885-1980 MHz, 2010-2025 MHz and 2110-2170 MHz in Regions 1 and 3 and 1885- 1980 ...

16

A Comparitive Analysis of SVC, STATCOM and UPFC for Voltage Regulation in Power System

A Comparitive Analysis of SVC, STATCOM and UPFC for Voltage Regulation in Power System

... where control of active and reactive power is ...and control strategy of UPFC is presented in ...reactive power during fault ...machine power systems is studied from [10].UPFC enables ...

9

Distributed LQR Design for a Class of Large-Scale Multi-Area Power Systems

Distributed LQR Design for a Class of Large-Scale Multi-Area Power Systems

... The control scheme was obtained by optimizing an LQR performance index with a tuning parameter utilized to emphasize/de-emphasize relative state difference between interconnected ...tie-line power ...

29

Load Frequency Control of a Hydrothermal Power System under Deregulated Environment

Load Frequency Control of a Hydrothermal Power System under Deregulated Environment

... in system loading condition and inertia ...a power system. The performance of the given proposed controller has more accurate than that of the other conventional I,ID,2DOFID and 3DOFID ...

5

Show all 10000 documents...

Related subjects