power system fault location
Intelligent impedance based fault location for zonal power systems
... the system. A low impedance indicates a fault has occurred; assuming this impedance is dominated by the cable impedance to the fault, the fault may be located by comparing the calculated ...
5
Fast fault location scheme for distribution systems based on fault transients
... based fault location method using circuit analysis of the high frequency responses generated due to the fault is used to locate faults in integrated power distribution ...a system with ...
6
Improvement of Power System Transient Stability Using a Controllable Resistor Type Fault Current Limiter
... type fault current limiter (FCL) is introduced for enhancement of transient stability of single machine infinite bus (SMIB) system with a double circuit transmission ...during fault to reach the ...
6
Investigation of superconducting fault current limiter application in a power-dense marine electrical network
... SFCL location strategy has been tested with an SFCL impedance of ...a fault at the 690V bus-tie (fault ...the fault current for location strategy A. By inspection of the system ...
6
Electric Power Supply Network Management Using GIS Solution
... network fault location algorithm, which greatly improve the distribution system fault locating efficiency, and ensure the distribution network of safe, reliable ...network fault ...
8
Reliability Improvement of Radial Distribution System with Smart Grid Technology
... distribution system, remotely controlled high rated power electronic switches are used in the place of normal disconnecting switches on ...distribution system, these act as normally closed ...
5
Wind Turbine Monitoring and Diagnosis Using CAN
... are fault prone, that is they are deployed in harsh environment such as desert, plains apart from that they are complex electromechanical system that are located far away from the control ...of fault ...
5
Fuzzy Logic Approach for Fault Diagnosis of three Phase Transmission Line
... actual fault location. Fault type and malfunctioning type of protective devices such as relays and ...a fault event in the power system. Thus, Good Fault Diagnosis method ...
5
Grid connected wind turbines A simulation study
... the power system during the faults by using PSCAD and ...The power system simulation used in this paper consists of an AC generator of a power rating 1 MVA and a wind turbine generator ...
6
Architecture Design for Integrated Wide Area Protection and Control Systems
... the system, which great- ly increase the number of ...accurate fault location and the contents of ...cessing power base on ...cloud system, such as the wide area information sharing; ...
5
Efficient Generation of Power In Medium Voltage Direct Current Systems: Variable Speed Operation and Rectifier Considerations
... electric power systems can lead to cascading power outages which cause tremendous loss to the economy and affect people’s ...of power system condition. By knowing exactly where a fault ...
80
An Accurate Power System Fault Classification and Location Algorithm for Series Compensated Line
... The fault resistance, system impedance and equivalent electromotive forces are all constant during the ...the fault is essential for computing the fault distance as well as for proper ...
6
Fault location and diagnosis in a medium voltage EPR power cable
... SEM system used in the present investigation also facilitates Energy Dispersive X-ray (EDX) spectroscopy, which allows the elemental composition of materials to be ...
9
Ground Fault Location in Distribution System Using MATLAB
... Electric power distribution system is the final stage in the delivery of electric power; it carries electricity from the transmission system to individual ...transmission system and ...
7
Vol 3, No 1 (2017)
... of power system. Accurate fault location algorithm plays a vital role to estimate the location of these ...based fault location algorithm have been increasingly ...
6
Fault current Characterization Based on Fuzzy Algorithm for DOCR Application
... into power system might disturb the existing fault diagnosis ...of fault, fault classification, and random changes of direction of fault current cannot always be monitored and ...
5
EFFECT OF FAULT LOCATION AND LOAD INCREMENT ON TRANSIENT STABILITY OF POWER SYSTEM
... of power system operation. A power system at a given operating state is stable if following a given disturbance, or a set of disturbances, the system state stays within specified bounds ...
9
Development and testing of an experimental power system fault demonstrator
... the fault detection ...the fault occurs close to the voltage zero crossing, the current will not exceed the threshold until part-way through the next half ...the fault location al- gorithm is ...
6
Marine power distribution system fault location using a portable injection unit
... Fault location methods which can provide the exact fault distance between the measurement units and the fault points have been considered as a primary/backup protection in power ...
8
Fault diagnosis for transmission lines using chromatic processing
... The power system size transition from a simple source-load systems into complex-interconnected networks aiming to provide an integrated service over larger areas increased the need for efficient and ...
244