• No results found

Reinforcement Ratio

Effect of reinforcement ratio and cross section dimensions on the reliability index of slender reinforced concrete columns

Effect of reinforcement ratio and cross section dimensions on the reliability index of slender reinforced concrete columns

... the reinforcement yield strength, the loads, the reinforcement ratio, the ction, and the location of steel ...the reinforcement ratio and the cross section dimensions on the reliability ...

7

Interaction of bending and punching of reinforced concrete slabs subjected to impact by deformable missiles in impact iii project tests

Interaction of bending and punching of reinforced concrete slabs subjected to impact by deformable missiles in impact iii project tests

... transverse reinforcement needs FE modelling by use of volume elements when attaining the ultimate punching ...shear reinforcement appears to be overestimated to a small extent by the relevant German code ...

10

Effect of partial replacement of coarse aggregate by polystyrene balls on the shear behaviour of deep beams with web openings

Effect of partial replacement of coarse aggregate by polystyrene balls on the shear behaviour of deep beams with web openings

... transverse reinforcement ratio and a/d ...main reinforcement ratio, the internal stiffening of the opening perimeter using additional reinforcement on the shear behavior of LWC deep ...

26

Comprehensive Study on the effect of Discrete Steel Fibre in Short Beams

Comprehensive Study on the effect of Discrete Steel Fibre in Short Beams

... depth ratio, depth of beam elements, aspect ratio of fibres and mix proportions were maintained constant, while tensile reinforcement ratio and fiber content were changed for each set of ...

10

Shear strength assessment of 
		self compacting concrete beams using lasso regression technique

Shear strength assessment of self compacting concrete beams using lasso regression technique

... where ๐›พ = the concrete partial safety factor and equals 1.5; K = the size effect factor ( ๐พ = 1 + โˆš200/๐‘‘ < 2 ); ๐œŒ ๐‘ค = the longitudinal reinforcement ratio, ๐œ‚ = the factor to account for lightweight ...

10

Experimental and Analytical Investigation of Flexural Behavior of Reinforced Concrete Beam

Experimental and Analytical Investigation of Flexural Behavior of Reinforced Concrete Beam

... different reinforcement ratio (under, balanced, over) and observation was focused on the same as before also comparison of first cracking load, ultimate load, work-done in linear and nonlinear region, and ...

8

Effects of Variation of Axial Load on Seismic Performance of Shear Deficient RC Exterior BCJs

Effects of Variation of Axial Load on Seismic Performance of Shear Deficient RC Exterior BCJs

... aspect ratio of joint, column reinforcement ratio and axial load on column up to ALR of ...aspect ratio, beam reinforcement ratio and column axial load in estimating shear ...

20

Static loading test on seismic capacity of reinforced concrete shear walls in nuclear power plant part 2 evaluation of damage and residual capacity

Static loading test on seismic capacity of reinforced concrete shear walls in nuclear power plant part 2 evaluation of damage and residual capacity

... wall reinforcement at the cycle of ...vertical reinforcement in the left half of the wall panel at regular intervals: 0mm, 240mm, 480mm, and 720mm from the center of the wall ...of reinforcement ...

10

A design model for punching shear of FRP-reinforced slab-column connections

A design model for punching shear of FRP-reinforced slab-column connections

... FRP reinforcement ratio and, very importantly, different types of FRP reinforcement with varied manufacturing processes, elastic modulus and ultimate tensile ...strength ratio is ...

40

Aggregate index: A measure for calibrating 
		shear strength models for direct application to self consolidating 
		concrete beams

Aggregate index: A measure for calibrating shear strength models for direct application to self consolidating concrete beams

... shear reinforcement was compiled for the ...depth ratio, longitudinal reinforcement ratio, maximum aggregate size and fine to coarse aggregate ratio were all relevant parameters in ...

11

ABSTRACT: This paper studies the performance UHPFRC columns loaded with eccentric compressive loads.

ABSTRACT: This paper studies the performance UHPFRC columns loaded with eccentric compressive loads.

... eccentricities, HPC columns give the highest load capacity and ductility of concrete strength types. Hung et al. [8] studied the behavior of UHPC slender eccentrically loaded columns. The eight tested specimens had ...

7

Material Price Enfluence on the Optimum Design of Different Structural Members

Material Price Enfluence on the Optimum Design of Different Structural Members

... cost ratio of about 75 once and again with a cost ratio of about 15, in order to realize the difference between the expensive and cheep materials ...the reinforcement ratio was limited between ...

8

Modelling of R/C members accounting for shear failure localisation: Hysteretic shear model

Modelling of R/C members accounting for shear failure localisation: Hysteretic shear model

... longitudinal reinforcement leads to a decreased post-peak slope, mainly through the dowel action of the longitudinal bars, as well as carrying an (occasionally significant) part of the vertical load, hence ...

23

Local failure modes of sc walls subjected to impactive loading

Local failure modes of sc walls subjected to impactive loading

... A design methodology of SC walls subjected to missile impact was proposed by Bruhl et al. (2015a) to prevent perforation failure, and results from tests designed specifically to evaluate this design method have been ...

10

Cyclic out-of-plane shear behaviour of sc composite structures

Cyclic out-of-plane shear behaviour of sc composite structures

... shear reinforcement spacing. The increase in the shear reinforcement ratio is shown to increase the shear strength, but also resulted in altering the failure mode from shear failure to flexural ...

10

Finite element model for predicting the shear behavior of FRP-strengthened RC members

Finite element model for predicting the shear behavior of FRP-strengthened RC members

... transversal reinforcement ratios of ...FRP reinforcement ratios as of ๏ฒ f ๏€ฝ 0 ...steel reinforcement ratios in transvers al ...steel ratio on the softening ...steel reinforcement ...

45

Online Full Text

Online Full Text

... reinforcement ratio. No. 3 rebars were used as the shear reinforcement and grade 70 high strength steel conforming to ASTM/ASME SA 516 was used as the top and bottom steel ...reinforcement ...

6

Experimental and Numerical Assessment of Reinforced Concrete Beams with Disturbed Depth

Experimental and Numerical Assessment of Reinforced Concrete Beams with Disturbed Depth

... the reinforcement lay-out and amount as well as anchorage zone cracking on the load capacity of RC beams with dapped region, called โ€œhalf-joint beamsโ€ in their ...shear reinforcement in the form of vertical ...

28

Self-Consolidating Ultra-High Performance Concrete for Small Modular Reactor Construction

Self-Consolidating Ultra-High Performance Concrete for Small Modular Reactor Construction

... Various mixture proportions were tested to achieve the optimum flowability and compressive strength with different parameters such as the amount of fly ash, silica fume, FGS; and different types of superplasticizer, ...

10

The influence of ratio reinforcement on video gaming behaviour

The influence of ratio reinforcement on video gaming behaviour

... basic reinforcement in prolonging gaming duration, future research must expand into more modern gaming ...videogame reinforcement to contribute to the gaming ...

66

Show all 10000 documents...

Related subjects