• No results found

reference signal

Investigation of the Psychological factors determining the Magnitude of Auditory Sensation

Investigation of the Psychological factors determining the Magnitude of Auditory Sensation

... 1000 Hz tone pure tone and 4000 Hz pure tone. Insignificant differences between the means and variances of perceived loudness levels for both the 1000 Hz and 4000 Hz pure tones were found. The positive correlation ...

13

Feedforward Linearization Technique to Reduce Intermodulation Distortion and Spourius Free Dynamic Range(SFDR) Measurements

Feedforward Linearization Technique to Reduce Intermodulation Distortion and Spourius Free Dynamic Range(SFDR) Measurements

... input signal power, thus only strong interferers near to desired signals or bands for secondary transmissions are identified in the first ...input signal level (mid of 40 dB level difference) has been used ...

5

Grid Connected Third Harmonic Injection PWM in a Multilevel Inverter Control with Proportional Resonant Controller

Grid Connected Third Harmonic Injection PWM in a Multilevel Inverter Control with Proportional Resonant Controller

... dc signal to ac signal ...a reference signal with a carrier signal. The reference signal is in the form of sinusoidal or square wave and the carrier signal may be ...

7

An Alternative for PID control: Predictive Functional Control - A Tutorial

An Alternative for PID control: Predictive Functional Control - A Tutorial

... Remark 1: With a stepwise change in the reference (or disturbance) signal, a constant MV can be assumed. With another type of reference signal (e.g. sum of polynomial functions) the MV ...

7

Execution and Performance Evaluation of Different Noise Cancellation Techniques 

Execution and Performance Evaluation of Different Noise Cancellation Techniques 

... primary signal den) which is wanted signal (say sen) ) corrupted by noise (say n(n) ...is reference signal x(n) can be interfacing noise supposed to be uncorre1ated with the wanted ...

6

Optimization Capabilities of LMS and SMI Algorithm for Smart Antenna Systems (RESEARCH NOTE)

Optimization Capabilities of LMS and SMI Algorithm for Smart Antenna Systems (RESEARCH NOTE)

... desired signal from a set of signals available in faded ...increasing signal to noise ratio and enhancing system capacity [2, ...of signal. These non-lind algorithms use a reference ...

8

Delay Spoofing Reduction in GPS Navigation System based on Time and Transform Domain Adaptive Filtering

Delay Spoofing Reduction in GPS Navigation System based on Time and Transform Domain Adaptive Filtering

... GPS signal and “y(n)” is estimate of authentic ...primary signal and nearly acceptable approximation of authentic GPS signal is yielded at output of the filter as “e(n)” ...authentic signal ...

14

Control Using Sliding Mode Of the Magnetic Suspension System

Control Using Sliding Mode Of the Magnetic Suspension System

... An approach for controlling the magnetic suspension system based on sliding mode has been presented. The model of the magnetic suspension has been realised using the simple electromagnetic and a steel ball. The ...

5

DOA Estimation and Adaptive Beamforming for Smart Antenna System using DSP Algorithm

DOA Estimation and Adaptive Beamforming for Smart Antenna System using DSP Algorithm

... normally requires either the knowledge of a reference signal (or training signal), or the direction of the desired signal source. There exists a range of schemes to estimate the direction of ...

8

Fuzzy-PID Control Strategy for Grid Interface Ocean Wave Energy Conversion

Fuzzy-PID Control Strategy for Grid Interface Ocean Wave Energy Conversion

... the reference values of and can be determined directly from the and ...actual signal of the rotor flux ( ) is compared with it’s the command ( to form the rotor flux error ...the reference ...

8

Performance Enhancement of OFDM System using Hybrid Channel Estimation with Pseudo Pilot

Performance Enhancement of OFDM System using Hybrid Channel Estimation with Pseudo Pilot

... etc. signal get distorted. To recuperate original transmitted signal at receiver end we need to find channel response which can be obtain by using channel estimation techniques like [5] Least Square ...

6

Widefield two laser interferometry

Widefield two laser interferometry

... the signal generated by one pixel to mix with the detected signal at all other pixels, tracking any changes in frequency and phase relative to that single ...the signal before it is used as the ...

8

Design of low offset Dynamic Comparators for High speed ADC Architectures

Design of low offset Dynamic Comparators for High speed ADC Architectures

... sampled signal is then applied to a combination of comparators to determine the digital equivalent of the analog ...a signal is greater or smaller than zero or to compare an input signal with a ...

9

Enhanced Locating Method for Cable Fault Using Wiener Filter

Enhanced Locating Method for Cable Fault Using Wiener Filter

... estimated signal with the injected reference signal, and provide experimental results to show the performance improvement of fault detection and location using TDR with Wiener filter in power ...

5

Simulation Development of Carrier based Pulse Width Modulation for Cascaded Multilevel Inverter

Simulation Development of Carrier based Pulse Width Modulation for Cascaded Multilevel Inverter

... a reference signal, a triangle waveform generator within variable frequency, CMLI unit, and load and CBPWM control ...A reference signal is a sin signal generator, which frequency ...

6

Estimating the number of components of a multicomponent nonstationary signal using the short-term time-frequency Rényi entropy

Estimating the number of components of a multicomponent nonstationary signal using the short-term time-frequency Rényi entropy

... nonstationary signal, relative to the short-term Rényi entropy of a reference signal, the number of components present in the signal can be accurately ...analyzed signal, nor the ...

11

On The Use Of Machine Learning For Temporal Performance Prediction In Lte Advanced Networks

On The Use Of Machine Learning For Temporal Performance Prediction In Lte Advanced Networks

... location, Reference Signal Received Power (RSRP), Reference Signal Received Quality (RSRQ), signal-to-interference-plus-noise ratio (SINR) and ———————————————— ...

6

A Novel Approch for Fetal Ecg Using Adaptive Filter Algorithm

A Novel Approch for Fetal Ecg Using Adaptive Filter Algorithm

... maternal signal separation. These methods use one or more reference maternal signals for training an adaptive or matched filter, or directly training the filter without reference signal for ...

14

International Journal of Emerging Technology and Advanced Engineering Website: www.ijetae.com (ISSN 2250-2459, ISO 9001:2008 Certified Journal, Volume 9, Issue 6, June 2019)

International Journal of Emerging Technology and Advanced Engineering Website: www.ijetae.com (ISSN 2250-2459, ISO 9001:2008 Certified Journal, Volume 9, Issue 6, June 2019)

... analog signal into corresponding digital ...analog signal. That signal is in the form of stair case as shown in ...analog signal by using low pass ...

7

Performance Analysis of Cascaded Adaptive Algorithms for Noise Cancellation in Speech Signal

Performance Analysis of Cascaded Adaptive Algorithms for Noise Cancellation in Speech Signal

... This is about the execution of the cascaded structuralimplementation of the variable step size normalized least mean square algorithm(C-VSSLMS). In LMS algorithm the excess mean square error of the filter is increases ...

10

Show all 10000 documents...

Related subjects