• No results found

Signal-to-interference ratio

Deadline Maximum Signal to Interference Ratio Scheduling Algorithm for WiMAX

Deadline Maximum Signal to Interference Ratio Scheduling Algorithm for WiMAX

... maximum Signal to Interference Ratio scheduler , which makes bandwidth allocation decisions based on information about the channel quality and ...

6

Empirical Analysis of Signal-to-Interference Ratio Variations in IEEE 802.11b WLAN

Empirical Analysis of Signal-to-Interference Ratio Variations in IEEE 802.11b WLAN

... the signal-to-interference ratio variations in IEEE ...detected signal strength of the access points was ...the signal distance and the signal to interference ratio ...

8

SIGNAL TO INTERFERENCE-NOISE RATIO BASED FIXED STEP SIZE POWER CONTROL ALGORITHM FOR WCDMA SYSTEM

SIGNAL TO INTERFERENCE-NOISE RATIO BASED FIXED STEP SIZE POWER CONTROL ALGORITHM FOR WCDMA SYSTEM

... multichannel interference and noise is a major factor in constraining the performance of WCDMA ...user signal to interference ratio has been decreased as the data rate increases ...target ...

10

A Gradient-Based Optimum Block Adaptation ICA Technique for Interference Suppression in Highly Dynamic Communication Channels

A Gradient-Based Optimum Block Adaptation ICA Technique for Interference Suppression in Highly Dynamic Communication Channels

... source signal matrix, which is to be recovered by ICA al- gorithm based on the assumption of statistical independence between the desired signal and the ...input signal-to-interference ...

10

Non Negative Matrix Factorization Based UKF Algorithm for Constant Modulus Signals in Adaptive Beamforming

Non Negative Matrix Factorization Based UKF Algorithm for Constant Modulus Signals in Adaptive Beamforming

... gain, signal to interference plus noise ratio (SINR) and mean squared deviation (MSD) as the noise variance and the array size increase with reduced computational complexity with the ...

10

Sideband Noise Mitigation in a Co-Located Network Involving CDMA2000 and WCDMA System

Sideband Noise Mitigation in a Co-Located Network Involving CDMA2000 and WCDMA System

... RF signal is amplified to form the transmit signal, a significant amount of emissions are generated outside the transmit band referred to as sideband noise emission ...to Interference (C/I) ...

8

Optimizing time and space MIMO antenna system for frequency selective fading channels

Optimizing time and space MIMO antenna system for frequency selective fading channels

... co-channel interference (CCI). In [15], the signal-to-noise ratio (SNR) is maximized by using a joint multiple transmission and reception filter ...intersymbol interference (ISI) and CCI is ...

13

IEEE802.16 OFDMA, AMC, HARQ,

IEEE802.16 OFDMA, AMC, HARQ,

... The interference is one of major problems in wireless networks, frequency reuse and Adaptive Modulation Scheme (AMC) and Hybrid Automatic Repeat request (HARQ) are different network deployment causes to retain ...

6

DME interference suppression algorithm based on signal separation estimation theory for civil aviation system

DME interference suppression algorithm based on signal separation estimation theory for civil aviation system

... L5 signal is set up and takes up an appointed frequency ...equipment) signal which has already applied for distance measurement in the civil aviation system works as the same frequency band as GPS L5 ...

8

Traditional protection ratios in FM sound broadcasting – still appropriate for interference management?

Traditional protection ratios in FM sound broadcasting – still appropriate for interference management?

... additional interference. The extent to which interference from other FM signals has to be toler- ated is governed by mandatory protection ratios, which have been agreed by the ITU conference held in 1984 in ...

6

Robust Adaptive Sidelobe Canceller Using SV Mismatch Estimation

Robust Adaptive Sidelobe Canceller Using SV Mismatch Estimation

... overcome signal-to-interference-and-noise ratio (SINR) performance degradation in the presence of steering vector (SV) mismatch between beam pointing and desired signal’s SVs, we study the mismatch ...

8

Performance Analysis of Antenna Array Beamformers with Mutual Coupling Effects

Performance Analysis of Antenna Array Beamformers with Mutual Coupling Effects

... output signal-to-interference-plus-noise ratio (SINR) for the performance of antenna array beamformers under MC ...of signal correlation matrix under MC ...

25

Application of Microwave Integrators for Interference Suppression

Application of Microwave Integrators for Interference Suppression

... main signal power is set at 0.5 W, and the interfering signal is set at 3 ...main signal strength and interfering signal strength are − 43 ...main signal to be set at an FM modulation ...

10

Signal Interference Analysis Model In Near-Field Coupling Communication

Signal Interference Analysis Model In Near-Field Coupling Communication

... a signal electrode (#1) and a ground electrode (#2) of the wearable TRX, a floor ground (#3), an embedded lower electrode (#4), an embedded upper electrode (#5), phantom 1 (#6), and phantom 2 (#7), as shown in ...

6

Adaptive Coordinated Reception for Multicell MIMO Uplink

Adaptive Coordinated Reception for Multicell MIMO Uplink

... the interference limited cellular systems is challenging and has been studied for ...certain signal-to-interference-plus-noise ratio (SINR) requirement per MS, Yates and Huang reformulated ...

11

A SURVEY OF SPECTRUM SENSING TECHNIQUES FOR COGNITIVE RADIO NETWORKS

A SURVEY OF SPECTRUM SENSING TECHNIQUES FOR COGNITIVE RADIO NETWORKS

... Spectrum sensing is a challenging issue in cognitive radio (CR) environment. As a result, it has been reborn as a very active innovative area in recent years. Although various spectrum sensing techniques have been ...

8

Experimental Investigation of TDD Reciprocity-Based Zero-Forcing Transmit Precoding

Experimental Investigation of TDD Reciprocity-Based Zero-Forcing Transmit Precoding

... and signal to interference noise and distortion ratio (SINDR) are presented for a scenario with two base-stations and two mobile stations, with two antennas at the base-stations and a single antenna ...

10

A Novel Approach to Implement Efficient SINR and Side-Lobe Reduction by Using MIMO Radar Covariance Matrix

A Novel Approach to Implement Efficient SINR and Side-Lobe Reduction by Using MIMO Radar Covariance Matrix

... in signal-to-noise ratio due to non-coherent ...the signal-to-interference-plus-noise ratio (SINR) compared to MIMO radar and have lower sidelobe levels (SLLs) compared to phased-array, ...

6

Interference State Estimation Based Weight Setting for Multichannel Joint Detection

Interference State Estimation Based Weight Setting for Multichannel Joint Detection

... low signal-to-noise ratio (SNR) and the presence of time-varying interference in passive radar target detection, multi-channel joint detection is considered as an effective solution, performance of ...

6

A REVIEW PAPER OF PERFORMANCE ASSESSMENT OF UWB-IR CLASSIFICATIONDheeraj Patil, Pallavi Pahadiya

A REVIEW PAPER OF PERFORMANCE ASSESSMENT OF UWB-IR CLASSIFICATIONDheeraj Patil, Pallavi Pahadiya

... The goal of this paper is to analyze and propose an efficient WSN architecture based on IR-UWB and validate it using engineering simulation. As an alternative MACPHY, layer for 802.15.4a based WSN, several IR- UWB ...

11

Show all 10000 documents...

Related subjects