interference-to-signal ratio
DME interference suppression algorithm based on signal separation estimation theory for civil aviation system
... L5 signal is set up and takes up an appointed frequency ...equipment) signal which has already applied for distance measurement in the civil aviation system works as the same frequency band as GPS L5 ...
8
Optimizing time and space MIMO antenna system for frequency selective fading channels
... average signal-to-interference and noise ratio (SINR) of each packet in the system for frequency selective channels with prior knowledge of the channel at the ...
13
Interference State Estimation Based Weight Setting for Multichannel Joint Detection
... low signal-to-noise ratio (SNR) and the presence of time-varying interference in passive radar target detection, multi-channel joint detection is considered as an effective solution, performance of ...
6
SIGNAL TO INTERFERENCE-NOISE RATIO BASED FIXED STEP SIZE POWER CONTROL ALGORITHM FOR WCDMA SYSTEM
... The cellular CDMA networks control algorithms utilizes the concept of signal to noise ratio in calculating the required output power for transmission at various data rate application. This is due to fact ...
10
Title: ARBITARY DISTRIBUTED SHADOWING FOR IMPROVING QUALITY OF REAL TIME STREAMING IN WIRELESS CELLULAR NETWORKS
... the signal-to-interference- and- noise-ratio (SINR) experienced by a typical user in the downlink channel from the k-th strongest base stations of a cellular network modeled by Poisson point process ...
11
Signal Interference Analysis Model In Near-Field Coupling Communication
... a signal electrode (#1) and a ground electrode (#2) of the wearable TRX, a floor ground (#3), an embedded lower electrode (#4), an embedded upper electrode (#5), phantom 1 (#6), and phantom 2 (#7), as shown in ...
6
Performance Analysis of Antenna Array Beamformers with Mutual Coupling Effects
... output signal-to-interference-plus-noise ratio (SINR) for the performance of antenna array beamformers under MC ...of signal correlation matrix under MC ...
25
Adaptive Coordinated Reception for Multicell MIMO Uplink
... individual signal-to-interference-plus-noise ratio (SINR) constraint per MS, power control and receive beamforming are jointly optimized with adaptive MBS selection to minimize the total transmit ...
11
Bit Error Rate Prediction of Coded MIMO-OFDM Systems
... Bit error rate (BER) prediction over channel realisations has emerged as an active research area. In this paper, we give analytical signal to interference and noise ratio (SINR) evaluation of ...
6
Robust Adaptive Sidelobe Canceller Using SV Mismatch Estimation
... overcome signal-to-interference-and-noise ratio (SINR) performance degradation in the presence of steering vector (SV) mismatch between beam pointing and desired signal’s SVs, we study the mismatch ...
8
A Gradient-Based Optimum Block Adaptation ICA Technique for Interference Suppression in Highly Dynamic Communication Channels
... source signal matrix, which is to be recovered by ICA al- gorithm based on the assumption of statistical independence between the desired signal and the ...input signal-to-interference ...
10
Sideband Noise Mitigation in a Co-Located Network Involving CDMA2000 and WCDMA System
... RF signal is amplified to form the transmit signal, a significant amount of emissions are generated outside the transmit band referred to as sideband noise emission ...to Interference (C/I) ...
8
Traditional protection ratios in FM sound broadcasting – still appropriate for interference management?
... additional interference. The extent to which interference from other FM signals has to be toler- ated is governed by mandatory protection ratios, which have been agreed by the ITU conference held in 1984 in ...
6
A framework for assessing the performance of pulsar search pipelines
... frequency interference (RFI) on the signal to noise ratio, the number of false positives detected per true positive and the sensitivity of standard pulsar search ...
18
A SURVEY OF SPECTRUM SENSING TECHNIQUES FOR COGNITIVE RADIO NETWORKS
... Spectrum sensing is a challenging issue in cognitive radio (CR) environment. As a result, it has been reborn as a very active innovative area in recent years. Although various spectrum sensing techniques have been ...
8
Non Negative Matrix Factorization Based UKF Algorithm for Constant Modulus Signals in Adaptive Beamforming
... gain, signal to interference plus noise ratio (SINR) and mean squared deviation (MSD) as the noise variance and the array size increase with reduced computational complexity with the ...
10
Conceptual Design of a Dispersion Interferometer Using a Ratio of Modulation Amplitudes
... ones: (i) restriction of phase where Eq. (2) is a monotonic function and (ii) the necessity for calibration experiments of the detected intensity A and B and their variations dur- ing discharges lead to phase errors. The ...
5
Application of Microwave Integrators for Interference Suppression
... the signal-to-noise ratio ...main signal at ...perform signal analysis of the RF signals. To compare the interference suppression of the integrators with the interference ...
10
Deadline Maximum Signal to Interference Ratio Scheduling Algorithm for WiMAX
... maximum Signal to Interference Ratio scheduler , which makes bandwidth allocation decisions based on information about the channel quality and ...
6
Empirical Analysis of Signal-to-Interference Ratio Variations in IEEE 802.11b WLAN
... the signal-to-interference ratio variations in IEEE ...detected signal strength of the access points was ...the signal distance and the signal to interference ratio ...
8