power-hardware-in-the-loop (PHIL)
Assessment and development of stability enhancing methods for dynamically changing power hardware-in-the-loop simulations
... of Power hardware-in- the-loop (PHIL) simulations into dynamically changing systems, ...and hardware under test changes, an adaptive Ideal Transformer Method (ITM) interface algorithm is ...
5
Power hardware-in-the-loop setup for developing, analyzing and testing mode identification techniques and dynamic equivalent models
... a power hardware-in-the-loop (PHIL) setup is developed, consisting of a modified benchmark high voltage (HV) grid, namely the Kundur two area power system ...Dynamic Power Systems Lab- ...
6
Performance optimisation of a flywheel energy storage system using the PNDC power hardware in the loop platform
... 540kVA Power Hardware in the Loop (PHIL) testing ...Electric Power and Propulsion Project Arrangement ...ship power system ...marine power system ...ship power system ...
10
Comparison of multiple power amplification types for power hardware-in-the-loop applications
... Power Hardware-in-the-Loop (PHIL) is a simulation technology that has received a massive growth of interest in the last couple of ...known Hardware-in-the-Loop (HIL) technology ...a ...
6
Improving the Performance of a Power Hardware In the Loop System by a New Interface Algorithm
... the power electronic equipment connecting to power grid, such as distributed generation, micro-grid, electric vehicles and other new technologies, many new devices will be introduced into the future ...
8
Realization of high fidelity power-hardware-in-the-loop capability using a MW-scale motor-generator set
... of power electronics-based amplifiers to enable PHIL capability has been widely reported, the use of Motor-Generator (MG) sets as the PHIL interfaces has not been fully ...the power amplifier, which offers ...
9
Ancillary service provision by demand side management : a real-time power hardware-in-the-loop co-simulation demonstration
... real-time power hardware-in-the-loop co-simulation platform achieved by the integration of PowerMatcher (PM) with the University of Strathclyde’s DNAP ...
7
Validation of algorithms to estimate distribution network characteristics using power-hardware-in-the-loop configuration
... the Power Network Demonstrations Centre (PNDC) have been working together in the development and validation of optimal sensor placement and network topology estimation ...A ...
6
Application of a MW-scale motor-generator set to establish power-hardware-in-the-loop capability
... a Power-Hardware-in-the-Loop (P-HiL) testbed coupled to a MW-scale Motor-Generator (MG) ...the power interaction between the model and physical ...
6
Initialization and synchronization of power hardware-in-the-loop simulations : a Great Britain network case study
... novel power components need to be tested before their wide scale deployment and (iii) where the interactions of modern components with the grid need to be captured to understand the implication of its ...between ...
14
A new control method for the power interface in power hardware-in-the-loop simulation to compensate for the time delay
... A comparison between the ITM interface algorithm and the ITM with time–delay compensation algorithm has been car- ried out. Figs. 7-9 show comparisons of V1 and V2 in the time domain, since this is the simplest and most ...
5
Power hardware in the loop platform for flywheel energy storage system testing for electric ship power system applications
... RTDS hardware and the real-time target of the Triphase is made possible by utilising a scalable, lightweight, high data-rate, link-layer serial protocol known as ...
8
European White Book on Real-Time Power Hardware in the Loop Testing : DERlab Report No. R- 005.0
... to power and adequacy, but also protec- tion, communication, and efficiency in general it was sufficient to test for the AC frequency only, but now higher bandwidth testing is required, how does the equipment ...
52
Multi-agent system with plug and play feature for distributed secondary control in microgrid—controller and power hardware-in-the-loop implementation
... The performance of MAS is proven by showing that the system is stable and frequency is controlled under various changes of the MG. Eight different scenarios with alteration of network topology are emulated as illustrated ...
21
Novel Supervisory Control Algorithm to Improve the Performance of a Real-Time PV Power-Hardware-In-Loop Simulator with Non-RTDS
... algorithm of the PV PHIL simulator, the PV array maintained the maximum output voltage V oc state. 305[r] ...
18
Harmonic-by-harmonic time delay compensation Method for PHIL simulation of low impedance power systems
... impedance power system such as: microgrids, marine or aero power systems, the simulation process becomes challenging due to the poor accuracy of the results achieved by the introduction of the time ...in ...
6
Hardware-in-Loop-Simulator for InnoSAT Attitude Control System
... The RCM4100 series is the first of the next-generation core modules that takes advantage of the new Rabbit® 4000 features such as hardware DMA, clock speeds of up to 60 MHz, I/O lines shared with up to six serial ...
5
Developing a hardware in-the-loop simulator for a backpack energy harvester
... backpack in the area of 2 Hz (f/f h = 1) is a lot smaller than the “rigid force” (the force of a conventional backpack), which theoretically could make the process of carrying a backpack easier. The same effect is shown ...
17
An Accelerated Hardware Software in The Loop Technique for Control Units
... integration at multiple abstraction layers, for systems containing both software and hardware components. As an example, CODIS (COntinuous DIscrete Simulation) [6] is a tool which can automatically produces ...
12
Hardware-in-the-loop implementation for an active heave compensated drawworks
... Abstract: This paper presents the setup and running of a hardware-in-loop (HIL) simulation for an active heave compensated (AHC) draw-works. A simulation model of the draw-works is executed on a PC to ...
11